Xirgo XT-2469 (CoAP)

Time zone offset.Number of 15-minute increments from UTC.

Event identifier:

0 - Reserved

1 - Ignition On / Trip Start / Engine On

2 - Ignition Off / Trip End / Engine Off

3 - Ignition On Periodic Report

4 - Ignition Off Periodic Report / Heartbeat

5 - Power-up Message

6 - Power-up Message on GPS Lock

7 - Power-up Message on GSM

8 - Low Battery Alert

9 - Accelerometer Shock Event

10 - Acceleration based on VBUS speed

11 - Acceleration based on GPS speed

12 - Stage 0 Periodic Event Reporting

13 - Stage 1 Periodic Event Reporting

14 - Stage 2 Periodic Event Reporting

15 - Battery Disconnect Event

16 - Battery Reconnect Event

17 - Battery Periodic Disconnect

18 - Direction Change

19 - Speed VBUS

20 - Speed GPS

23 - Odometer VBUS

24 - Odometer GPS

25 - Input 1 Set

26 - Input 2 Clear

27 - Input 2 Set

28 - Input 2 Clear

31 - Heartbeat

32 - Output Manual Override

33 - Diagnostics

34 - Movement Start

35 - Movement Stop

36 - System Report 0

37 - System Information

38 - Park

39 - Idle Start

40 - Idle Stop

41 - Idle Periodic

42 - Best Time

43 - ADC Threshold

44 - ADC Periodic

45 - Diagnostics 1

46 - Diagnostics 2

47 - Diagnostics 3

52 - Powerstage Transition

53 - Fuel Level Threshold Change

Cellular signal quality.The range of the values is dependent on the cellular module. When the RF power level of the received signal is the highest possible, the value 31 is reported. When it is not known, not detectable or currently not available, 99 is returned.

GPS lock status:

0 - None. Lock status unknown.

1 - Locked. GPS is locked, but the result is filtered. This can mean it has not been locked for enough consecutive solutions or an accuracy figure of merit is unsatisfactory to consider this position LockedGood.

2 - Unlocked. GPS solution is not locked.

3 - LockedGood. GPS solution is locked and integrated.

4 - Sleep. The GPS receiver is powered down.

5 - Filtered. The response has been filtered.

Boot count

Power-loss count

Device acceleration

Device deceleration

Device reset reason:

0 - Unknown reset.

1 - Hardware watchdog reset.

2 - Brown-out reset.

3 - Hibernate reset.

4 - User reset.

5 - Software reset. This is initiated by the embedded firmware.

6 - Power on reset.

7 - Main oscillator reset.

GPS Horizontal accuracy estimate

Ignition source:

0 - Ignition Unknown

1 - VBUS

2 - Alternator

4 - Accelerometer

8 - GPS MN

Virtual odometer GPS.Calculated mileage

GPS time since last lock

Trip idle time

Trip counter

Configuration hash

Cellular network time.Seconds since 00:00:00 January 1, 1970 UTC. A value of 0 indicates that the current time is not known

Device uptime

Firmware version

SIM CCID

Cellular IMEI

Cellular IMEI

Accelerometer X-Vector

Accelerometer Y-Vector

Accelerometer Z-Vector

Physical ADC ID:

0 - None

1 - Main voltage

2 - Battery voltage

3 - External ADC 1

4 - External ADC 2

5 - External ADC 3

Mask of ADC transition states

Power stage transtition information

Power stage transtition information

Battery voltage

Location FixType:

0 - None

1 - GPS

Location epoch time (last known)

Location heading (last known)

Location Dilution of precision (last known)

Location Horizontal accuracy (last known)