| video_uri |
video URI |
|
| video_type |
video type: video/mp4 |
|
| text |
information message |
|
| at |
Access network. 1-Ethernet 2-WIFI 3-2G |
|
| mt |
Media Type. 1-live view 2-playback 3-audio 4-file transmission 5-serial transmission |
|
| ch |
Media channel. starting from 1, 0 means no need for the channel. |
|
| mb |
mobile phone number |
|
| dt |
Device Type |
|
| ver |
Current version of device |
|
| ap |
The hotspot when MDVR connects to the sever in WiFi mode. |
|
| fuel_cons |
Fuel consumption |
|
| balance_fuel |
Balance fuel |
|
| mobile_net |
Mobile network. 0--unknown 1--normal 2--abnormal 3—not exist |
|
| gps_module |
GPS location module. 0--unknown 1--normal 2--abnormal 3—not exist |
|
| wifi_module |
WIFI module. 0--unknown 1--normal 2--abnormal 3—not exist |
|
| gsensor_status |
GSensor status. 0--unknown 1--normal 2--abnormal 3—not exist |
|
| recording_status |
Bit0 - channel 1 is recording
Bit1 - channel 2 is recording
Bit2 - channel 3 is recording
Bit3 - channel 4 is recording
Bit4 - channel 5 is recording
etc.
|
|
| status1 |
bit0 - ACC (0-invalid,
1-valid)
bit1-break (0-invalid, 1-valid)
bit2 - turn left (0-invalid,
1-valid)
bit3 - turn right (0-invaid,
1-valid)
bit4 - forward (0-invalid, 1-valid)
bit5 - backword (0-invalid,
1-valid)
bit6 - left front door (0-Close,
1-Open)
bit7 - right front door (0-close,
1-Open)
|
|
| status2 |
bit0 - left
mid door (0-close, 1-open)
bit1 - right
mid door(0-close, 1-open)
bit2 - left
back door(0-close, 1-open)
bit3 - right
back door(0-close, 1-open)
|
|
| x_accel |
GSensor acceleration, X axis |
g |
| y_accel |
GSensor acceleration, Y axis |
g |
| z_accel |
GSensor acceleration, Z axis |
g |
| gsensor_tilt |
GSensor tilt |
g |
| gsensor_impact |
GSensor impact |
g |
| position_accuracy |
Positioning accuracy |
m |
| location_type |
Location type. 0—location invalid; 1--GPS; 2--BD; 3--Glonass; 4--AGPS; 5--base station location; 6 - WIFI |
|
| mob_signal |
Mobile signal
intensity |
|
| mob_net_type |
Mobile network type:
0 - unknown
3 - 2G
4 - 3G
5 - 4G
6 - 5G
|
|
| wifi_signal |
Wi-Fi signal
intensity |
|
| wifi_net_addr |
Wi-Fi network address |
|
| wifi_gateway |
Wi-Fi gateway address |
|
| wifi_subnet |
Wi-Fi subnet mask |
|
| ssid |
Wi-Fi ssid |
|
| hdN_status |
Hard
disk N (disk index) status:
0 - unknown
1 - recording
2 - idle
3 - abnormal
4 - full
|
|
| hdN_size |
Hard disk N (disk index) size |
Mega Bytes |
| hdN_capacity |
Hard disk N (disk index) balance
capacity |
Mega Bytes |
| alarms |
Alarm
status:
bit0—video
loss (0: data invalid, 1: data valid)
bit1—motion
detection (0: data invalid, 1: data valid)
bit2—video
blind (0: data invalid, 1: data valid)
bit3—alarm
input trigger(0: data invalid, 1: data valid)
bit4—over
speed alarm (0: no trigger, 1: trigger)
bit5—low
speed alarm (0: no trigger, 1: trigger)
bit6—emergency
alarm (0: no trigger, 1: trigger)
bit7—over
time stop (0: no trigger, 1: trigger)
bit8—vibration
alarm (0: no trigger, 1: trigger)
bit9—out
of GEO fencing alarm (0: no trigger, 1: trigger)
bit10—enter
GEO fencing alarm (0: no trigger, 1: trigger)
bit11—exist
line alarm (0: no trigger, 1: trigger)
bit12-enter
line alarm (0: no trigger, 1: trigger)
bit13—fuel
level alarm (0: no trigger, 1: trigger)
|
|
| video_loss |
bit0 - channel 1 video loss indicator (0: no video loss, 1: video loss)
bit1 - channel 2 video loss indicator (0: no video loss, 1: video loss)
bit2 - channel 3 video loss indicator (0: no video loss, 1: video loss)
etc.
|
|
| motion |
Motion
detection:
bit0 - channel 1
bit1 - channel 2
etc.
|
|
| video_blind |
Video blind:
bit0 - channel 1
bit1 - channel 2
etc.
|
|
| alarm_inputs |
Alarm
inputs triggered:
bit0 - input 1
bit1 - input 2
etc.
|
|
| in_veh_temp |
Temperature in vehicle |
|
| out_veh_temp |
Temperature outside of vehicle |
|
| motor_temp |
Motor temperature |
|
| device_temp |
Device temperature |
|
| in_veh_hum |
Humidity in vehicle |
|
| out_veh_hum |
Humidity outside of vehicle |
|
| alarm_ec |
Event type code:
0 - unknown
1 - video lost
2 - motion detection
3 - video blind
4 - input trigger
5 - emergency alarm
6 - low speed alarm
7 - over speed alarm
8 - low temperature alarm
9 - high temperature alarm
10 - humidity alarm
11 - parking over time
12 - acceleration alarm
13 - GEO fencing
14 - electronic route
15 - abnormal openclose the door
16 - storage abnormal. Depending on st value, the meaning is the following: 0 - Missing; 1 - Broken ; 2 -The log cannot be overwritten; 3 - Failed to write Block; 4 - Disk failure; 5 - The disk cannot be mounted; 6 - Too many bad blocks storage; 7 - Disk invalid block; 8 - Disk video sampling verification failed; 9 - Disk pauses to write video; 10 - Disk recording overwrite exception; 11 - The disk has not recorded for a long time; 12 - The disk is written slowly 17 - fatigue driving
18 - fuel consumption abnormal
19 - illegal ACC
20 - GPS module abnormal
21 - front panel open
22 - Swipe card
23 - IBUTTON
24 - Harsh acceleration
25 - Harsh braking
26 - Low speed warning
27 - High speed warning
28 - Voltage alarm. Depending on dt value, the meaning is the following: 1 - low voltage; 2 - high voltage; 3 - Power off; 4 - Power on; 5 - Power off when moving; 6 - Low voltage shutdown; 7 - Start up. |
29 - People counting
30 - ADAS alarm
31 - “Acc on”. Report once at boot
32 Idle
33 Gps antenna break
34 Gps antenna short
35 IO output
36 CAN Bus connection abnormal
37 Towing <
38 Free wheeling
39 RPM exceeds
40 Vehicle Move
41 Trip start（st/et/dtu time same）
42 In trip
43 Trip ends (periodically report after acc off)
44 GPS location recover
45 Video abnormal
768 Trip notification
769 Upgrade notification
1280 Alarm file
281 Timer Snapshot
1282 Alarm file (in visible partition)
1283 ftp file upload notification |
|
|
| alarm_st |
Event start time |
|
| alarm_et |
Event end time |
|
| device_tm |
Event device time |
|
| swipe_card |
Swipe card number |
|
| sc_up |
Swipe card information. Onboard/offboard:
1 — Onboard
(check in)
2 — Off
board (check out)
Else — invalid
|
|
| sc_ht |
Swipe card information. History:
1 — Historical
data
2 — Real time data
Else — invalid
|
|
| adas_alarm_type |
ADAS: 1 - Forward collision alarm
2 - Lane departure warning
3 -Car distance too near
4 - Pedestrian collision alarm
5 - Frequent lane change alarm
6 - Road sign violate alarm
7 - Harsh Acceleration
8 - Harsh Breaking
9 - Safety Distance
16 - Traffic Sign Recognition
17 - FCW: Forward collision warning
18 - HMW: Headway monitoring warning
19 - Left Lane departure warning
20 - Right Lane departure warning
21 - VB Forward Collision Warning DMS:
33 - Fatigue driving alarm
34 - Phone call alarm
35 - Smoking alarm
36 - Distracted driving alarm
37 - Driver abnormal alarm
49 - Driver change event
65 - Eye closed
66 - Yawning
67 - Camera cover
68 - Distracted Driving
69 - Seat belt not fastened
70 - No driver
72 - Driver shift
73 - Driver back
80 - Infrared sunglasses
81 - Driver ID identified successfully
82 - Driver ID identified failed
83 - No Driver face detected
85 - Mask not worn
|
|
