| uart_msg_data |
UART message data
|
|
| alarm_flag |
0,2,3,5,6,9-14,17-27,29,30: Reserved the default as 0 Bit 1: Overspeed alarm Bit 4: GNSS fault Bit 7: Device main power under voltage Bit 8: Device main power off Bit 15: Remove alarm Bit 16: Vibration alarm Bit 28: Illegal displacement of the vehicle Bit 31: Reserved
|
|
| state_flag |
4-30: Reserved default is 0 Bit 0: 0-ACC off 1-ACC on Bit 1: 0-GNSS position unfix 1-GNSS position fix Bit 2: 0-north latitude 1-south latitude Bit 3: 0-east longitude 1-west longitude Bit 10: 0-fuel connect 1-fuel disconnect Bit 30: 0-normal data 1-TOW data Bit 31: 0-real time data 1-buffer data
|
|
| odometer |
Odometer
|
|
| gsm |
Mobile Network Signal Strength
|
|
| pwr_ext |
External supply voltage in mV
|
mV |
| fw_ver |
Firmware version
|
|
| bt_mac_# |
Bluetooth MAC, # - number of the device
|
|
| bt_rssi_# |
Bluetooth RSSI, # - number of the device
|
|
| bt_name_# |
Bluetooth name, # - number of the device
|
|
| bt_volt_# |
Bluetooth voltage, # - number of the device
|
|
| bt_temp_# |
Bluetooth temperature, # - number of the device
|
|
| bt_humidity_# |
Bluetooth humidity, # - number of the device
|
|
| bt_accel_X_# |
Bluetooth accelerometer sensor (X,Y,Z), # - number of the device
|
|
| wifi_mac_# |
WIFI MAC, # - number of the WIFI
|
|
| wifi_rssi_# |
WIFI RSSI, # - number of the WIFI
|
|
| gpio_ch_# |
GPIO channel, # - GPIO number
|
|
| gpio_st_# |
GPIO status, # - GPIO number
|
|
| light_# |
Sensors information: light
|
|
| temp |
Sensors information: temperature
|
|
| humidity |
Sensors information: humidity
|
|
| accel_X |
Sensors information: accelerometer
|
|
| pwr_int |
Battery voltage(mV)
|
mV |
| charge_st |
Charge status(optional): 1 byte 0: invalid 1: uncharged 2: charging 3: full charging 4: abnormal
|
|
| work_mode |
Work mode:1 byte 0: Periodic mode 1: Trigger mode 2: Tracking mode 3: Clock mode 4: Periodic mode+Trigger mode 5: Periodic mode+Tracking mode 6: Clock mode+Trigger mode 7: Tracking mode+Trigger mode 8: Periodic mode+Trigger mode+Tracking mode
|
|
| imei |
IMEI
|
|
| iccid |
ICCID
|
|
| device_type |
Device type
|
|
| gnss_age |
GNSS position age |
|
| acc_on_dur |
Duration of Acc on
|
|
| hdop |
HDOP
|
|
| di1_cnt |
DI1 counter
|
|
| bt_dev_fw_ver_# |
Bluetooth device firmware version, # - number of the device
|
|
| air_pressure |
Sensor information: air pressure
|
|
| ble_escort_dev_type_N |
Escort device type:
4 - DU-BLE
N - channel number
|
|
| ble_escort_sens_mode_N |
BLE Escort for Angle Sensor Modes are:
TRANSPORT_MODE = 0,
MODE_ROTATION_VERTICAL = 4,
MODE_ROTATION_HORIZONT = 5,
MODE_ANGLE_CONTROL = 6,
MODE_CONTAINER = 7,
MODE_EXCAVATOR = 9,
MODE_PLOW = 10,
MODE_INCLINOMETER_HORIZONT = 11,
MODE_INCLINOMETER_VERTICAL = 12
N - channel number
|
|
| ble_escort_rpm_N |
BLE Escort sensor
RPM (mode 4,5), range -50…+50
N - channel number
|
|
| ble_escort_evnt_notif_on_N |
BLE Escort sensor
01- event notification ON - the angle is crossed
N - channel number
|
|
| ble_escort_evnt_notif_cnt_N |
BLE Escort sensor Event notification counter (operating mode 7), range 0-65535
N - channel number
|
|
| ble_escort_tilt_angle_N |
BLE Escort sensor Tilt angle (operating modes 4,5), range 0-180
N - channel number
|
|
| ble_escort_tot_rev_cnt_N |
BLE Escort sensor total revolutions counter (operating modes 4,5) N - channel number
|
|
| ble_escort_temp_N |
BLE Escort sensor Temperature -70 to 125℃
N - channel number
|
℃ |
| ble_escort_roll_N |
BLE Escort sensor Roll (operating modes 11,12) -90 to 90 degrees
N - channel number
|
|
| ble_escort_pitch_N |
BLE Escort sensor Pitch (operating modes 11,12) -180 to 180 degrees
N - channel number
|
|
| ble_escort_pwr_int_N |
BLE Escort sensor Built-in battery voltage
N - channel number
|
V |
| ble_escort_fw_vers_N |
BLE Escort sensor Firmware version
|
|
| ble_escort_content_type_N |
BLE Escort sensor Content type:
9 - Escort DU
|
|
| ble_escort_name_N |
BLE Escort sensor Name
N - channecl number
|
|
| ble_escort_rssi_N |
BLE Escort sensor RSSI
N - channecl number
|
dBm |
| driver_id |
the driver identificator
|
|
