GPS tracker BR1201 | Integrated with Wialon

Features BR1201:

2G
4G/LTE
Caixa preta

The following data should also be added to BR1201 unit properties section of Wialon GPS tracking software :

Device type:	BR1201
ID único:	custom

Specify the following parameters in configuration software or configuration BR1201 for use in Wialon Hosting :

Porta do servidor:

22653

10 units of BR1201 device type are connected to Wialon Data Center. This represents 0% of all AVL Hardware connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name	Description	Units
param_id_#	Parameter value
uart_msg_mode	UART message mode
uart_msg_datatype	UART message datatype 0=ASCII, 1=BIN
uart_msg_data	UART message data
alarm_flag	0,2,3,5,6,9-14,17-27,29,30: Reserved the default as 0 Bit 1: Overspeed alarm Bit 4: GNSS fault Bit 7: Device main power under voltage Bit 8: Device main power off Bit 15: Remove alarm Bit 16: Vibration alarm Bit 28: Illegal displacement of the vehicle Bit 31: Reserved
state_flag	4-30: Reserved default is 0 Bit 0: 0-ACC off 1-ACC on Bit 1: 0-GNSS position unfix 1-GNSS position fix Bit 2: 0-north latitude 1-south latitude Bit 3: 0-east longitude 1-west longitude Bit 10: 0-fuel connect 1-fuel disconnect Bit 30: 0-normal data 1-TOW data Bit 31: 0-real time data 1-buffer data
odometer	Odometer
gsm	Mobile Network Signal Strength
pwr_ext	External supply voltage in mV	mV
fw_ver	Firmware version
bt_mac_#	Bluetooth MAC
bt_rssi_#	Bluetooth RSSI
bt_name_#	Bluetooth name
bt_fw_ver_#	Bluetooth firmware version
bt_volt_#	Bluetooth voltage
bt_temp_#	Bluetooth temperature
bt_hum_#	Bluetooth humidity
bt_sens_#	Bluetooth sensor (X,Y,Z)
wifi_mac_#	WIFI MAC
wifi_rssi_#	WIFI RSSI
gpio_ch_#	GPIO channel
gpio_st_#	GPIO status
data_type	Data type(0-63 is for GA series, 64-255 is for V series )： V series: 64:periodic trigger 65:power on trigger 66:ACC ignition 67:ACC flameout 68:VCC connect 69:VCC remove 70:virtual ignition(Gsensor) 71:virtual ignition(GNSSAST) 72:virtual flameout(Gsensor) 73:corner trigger 74:overspeed trigger 75:OTA start 76:OTA succeed 77:OTA failed 78:GNSS first fixed 79: low voltage trigger 80: low voltage release 81:Jamming trigger 82: distance trigger 83:crash trigger 84:DI1 trigger 85:DI2 trigger 86:DI3 trigger 87:DI4 trigger 88:DI5 trigger 89:DI6 trigger 90:DI7 trigger 91:DI8 trigger 92:DI9 trigger 93:DI10 trigger 94:AI upper limit trigger 95:AI lower limit trigger 96:battery low voltage trigger 97:battery low voltage release 98:battery start charging 99:battery full charged 100:soft reset trigger 101:virtual ignition(voltage) 102:virtual flameout(voltage) 103:TOW start 104:TOW stop 105: enter GEO-Fence 106: exit GEO-Fence
light_#	Sensors information: light
temp_#	Sensors information: temperature
hum_#	Sensors information: humidity
accel_#	Sensors information: accelerometer
limit_#	Sensors information: Limit (Light,Tmax,Tmin,Hmax,Hmin)
pwr_int	Battery voltage(mV)	mV
charge_st	Charge status(optional): 1 byte 0: invalid 1: uncharged 2: charging 3: full charging 4: abnormal
battery_level	Battery level	%
work_mode	Work mode:1 byte 0: Periodic mode 1: Trigger mode 2: Tracking mode 3: Clock mode 4: Periodic mode+Trigger mode 5: Periodic mode+Tracking mode 6: Clock mode+Trigger mode 7: Tracking mode+Trigger mode 8: Periodic mode+Trigger mode+Tracking mode
imei	IMEI
iccid	ICCID
device_type	Device type
gnss_age	GNSS position age
acc_on_dur	Duration of Acc on
hdop	HDOP
oil_levelN	The oil level value, N - the number of the level sensor (1 or 2)

Parameter name

Description

Units

param_id_#

Parameter value

uart_msg_mode

UART message mode

uart_msg_datatype

UART message datatype 0=ASCII, 1=BIN

uart_msg_data

UART message data

alarm_flag

0,2,3,5,6,9-14,17-27,29,30: Reserved the default as 0

Bit 1: Overspeed alarm

Bit 4: GNSS fault

Bit 7: Device main power under voltage

Bit 8: Device main power off

Bit 15: Remove alarm

Bit 16: Vibration alarm

Bit 28: Illegal displacement of the vehicle

Bit 31: Reserved

state_flag

4-30: Reserved default is 0

Bit 0: 0-ACC off 1-ACC on

Bit 1: 0-GNSS position unfix 1-GNSS position fix

Bit 2: 0-north latitude 1-south latitude

Bit 3: 0-east longitude 1-west longitude

Bit 10: 0-fuel connect 1-fuel disconnect

Bit 30: 0-normal data 1-TOW data

Bit 31: 0-real time data 1-buffer data

odometer

Odometer

gsm

Mobile Network Signal Strength

pwr_ext

External supply voltage in mV

fw_ver

Firmware version

bt_mac_#

Bluetooth MAC

bt_rssi_#

Bluetooth RSSI

bt_name_#

Bluetooth name

bt_fw_ver_#

Bluetooth firmware version

bt_volt_#

Bluetooth voltage

bt_temp_#

Bluetooth temperature

bt_hum_#

Bluetooth humidity

bt_sens_#

Bluetooth sensor (X,Y,Z)

wifi_mac_#

WIFI MAC

wifi_rssi_#

WIFI RSSI

gpio_ch_#

GPIO channel

gpio_st_#

GPIO status

data_type

Data type(0-63 is for GA series, 64-255 is for V series )：

V series:

64:periodic trigger 65:power on trigger 66:ACC ignition 67:ACC flameout 68:VCC connect 69:VCC remove 70:virtual ignition(Gsensor) 71:virtual ignition(GNSSAST)

72:virtual flameout(Gsensor) 73:corner trigger 74:overspeed trigger 75:OTA start 76:OTA succeed 77:OTA failed 78:GNSS first fixed 79: low voltage trigger 80: low voltage release

81:Jamming trigger 82: distance trigger 83:crash trigger 84:DI1 trigger 85:DI2 trigger 86:DI3 trigger 87:DI4 trigger 88:DI5 trigger 89:DI6 trigger

90:DI7 trigger 91:DI8 trigger 92:DI9 trigger 93:DI10 trigger 94:AI upper limit trigger 95:AI lower limit trigger 96:battery low voltage trigger 97:battery low voltage release

98:battery start charging 99:battery full charged 100:soft reset trigger 101:virtual ignition(voltage) 102:virtual flameout(voltage) 103:TOW start 104:TOW stop 105: enter GEO-Fence 106: exit GEO-Fence

light_#

Sensors information: light

temp_#

Sensors information: temperature

hum_#

Sensors information: humidity

accel_#

Sensors information: accelerometer

limit_#

Sensors information: Limit (Light,Tmax,Tmin,Hmax,Hmin)

pwr_int

Battery voltage(mV)

charge_st

Charge status(optional): 1 byte

0: invalid

1: uncharged

2: charging

3: full charging

4: abnormal

battery_level

Battery level

work_mode

Work mode:1 byte

0: Periodic mode

1: Trigger mode

2: Tracking mode

3: Clock mode

4: Periodic mode+Trigger mode

5: Periodic mode+Tracking mode

6: Clock mode+Trigger mode

7: Tracking mode+Trigger mode

8: Periodic mode+Trigger mode+Tracking mode

imei

IMEI

iccid

ICCID

device_type

Device type

gnss_age

GNSS position age

acc_on_dur

Duration of Acc on

hdop

HDOP

oil_levelN

The oil level value, N - the number of the level sensor (1 or 2)

Preencha um formulário de solicitação para começar

Produtos

Produtos de nicho para tarefas específicas

BR1201

More devices from the manufacturer

Entre em contato com a Gurtam e alcance seus mais ambiciosos objetivos através da telemática

Seja um parceiro

Solicite o Wialon na sua região

Preencha um formulário de solicitação para começar