| in_area |
In area alarm
|
|
| out_area |
Out area alarm
|
|
| enter_sleep |
Entering Sleep mode status
|
|
| low_power |
Low power alarm
|
|
| def5 |
User defined DEF(5) alarm
|
|
| def2 |
User defined DEF(2) alarm
|
|
| def1 |
User defined DEF(1) alarm
|
|
| illegal_ign |
Illegal ignition alarm
|
|
| def3 |
Door open alarm
|
|
| tow_away |
Tow away alarm/move alarm (ACC OFF)
|
|
| g_sens_alarm |
G-Sensor alarm
|
|
| def4 |
DEF (4)/Lora disconnect alarm
|
|
| power_cut |
Power cut alarm
|
|
| stop_overtime |
Stop over time alarm
|
|
| overspeed_alarm |
Over speed alarm
|
|
| sos |
SOS alarm
|
|
| idle_alarm |
Idle alarm
|
|
| fatigue_drive |
Fatigue alarm
|
|
| harsh_turning |
Harsh turning
|
|
| temp_abnormal |
Temperature abnormal
|
|
| gsm_jamming |
GSM Jamming alarm
|
|
| fuel_sens_disc |
Fuel Sensor Disconnect alarm
|
|
| temp |
Temperature value
|
C |
| fuel_level |
Fuel level
|
% |
| pwr_ext |
Power voltage of external device
|
V |
| fuel_level_jt |
Fuel level customized for JT fuel sensor
|
% |
| acc_on_time |
ACC ON time counting
|
minutes |
| fuel_value_percent |
Fuel value: upload unit 0.1%
|
|
| ibutton_sign_status |
Ibutton sign status - 0x00 sign in start
- 0x01 sign in status
- 0x02 sign out
|
|
| ibutton |
Ibutton card number
|
|
| battery |
Battery power percent
|
% |
| tyre_[NUM]_press |
TPMS Data Pressure value of [NUM] Tyre
|
|
| tyre_[NUM]_temp |
TPMS Data Temperature value of [NUM] Tyre
|
|
| tyre_[NUM]_status |
TPMS Data Status value of [NUM] Tyre
|
|
| multi_temp_[NUM] |
Multiple temperature data NUM - Id of the Temperature sensor
|
C |
| throttle_position |
Throttle Position
|
% |
| engine_load |
Engine Load
|
% |
| engine_coolant_temp |
Enigne coolant temperature
|
C |
| instantaneous_fuel_cons |
Instantaneous fuel consumption
|
1L / 100km |
| avg_fuel_cons |
Average fuel consumption
|
1L/100km |
| trip_distance |
Trip distance
|
km |
| total_mileage |
Total Mileage
|
km |
| trip_fuel_cons |
Trip Fuel consumption
|
L |
| accumulative_fuel_cons |
Accumulative Fuel consumption
|
L |
| dtc_code_num |
Number of DTC Code
|
|
| accelerate_alarm_times |
Accelerate alarm times triggering
|
|
| decelerate_alarm_times |
Decelerate alarm times triggering
|
|
| trip_time |
Trip time
|
seconds |
| trip_idle_time |
Trip Idle time
|
seconds |
| vin |
Vehicle vin code
|
|
| hum |
Humidity
|
% |
| adc |
AD voltage
|
V |
| smooth_height |
One Ultrasonic fuel sensor data
Smooth Height
|
mm |
| real_time_height |
One Ultrasonic fuel sensor Real time height
|
mm |
| pwr_int |
Battery voltage
|
V |
| rpm |
Engine speed
|
RPM |
| obd_speed |
Speed from OBD sensor
|
Km/h |
| ant_state |
GPS antenna status - 3: GPS antenna normal
- 2: GPS antenna short circuit
- 1: GPS antenna open circuit
- 0: GPS module error
|
|
| main_pwr_st |
Main power status - 3: Main power normal
- 2: Main power off
- 1: Main power abnormal (too high or too low)
|
|
| loc_mark |
Location status
|
|
| prot_diff_mark |
Mileage unit - 0: mileage unit m
- 1: mileage unit m
- 2: mileage unit Km
- 3: mileage unit Km
- 4: mileage unit 0.1 m
- 5: mileage unit 0.1 m
- 6: mileage unit 0.1 km
- 7: mileage unit 0.1 km
|
|
| fuel_pump_cut |
Fuel pump cut status - 0: immobilize
- 1: recover fuel pump
|
|
| energy_meter_conn |
- 1: Detach/light sensor alarm
- 0: Normal
|
|
| sleep |
- 1: In a sleep mode
- 0: Exit from sleep mode
|
|
| low_speed |
Low speed alarm
|
|
| csq |
GSM Signal strength: - The lowest signal strength: 0
- The highest signal strength: 31
|
|
| out_[NUM] |
- 1: OUT [NUM] enabled
- 0: OUT [NUM] disabled
|
|
| lock_wire_cut |
Lock wire status - 1: Lock wire cut
- 0: Lock wire normal
|
|
| lbs_loc |
- 0: GPS location
- 1: LBS location
|
|
| prot_mode |
Protection mode status
|
|
| unlock |
Lock status
|
|
| on_charging |
Charging status - 1: Charging mode
- 0: Discharging
|
|
| tamper |
- 1: casing/sim tamper
- 0: Normal
|
|
| sim_under_used |
Parameter that shows what sim card slot is used
|
|
| packet_code |
Parameter that shows message type of packet - Login – 0xB1
- One time track on demand – 0x30
- One time track on demand reply – 0x81
- Position Data Upload (by Interval, distance) – 0x80
- Blind Area Data re-Upload – 0x8E
- Cancel Geo-Fencing – 0x47
- Inquiry Geo Fencing – 0x48
- Set Geo-Fencing – 0x49
- Send Dispatch Info – 0x3A
- Alarm Info – 0x82(OLD)
- Alarm OFF – 0x83(OLD)
- Alarm Info – 0x82(NEW)
- Set Reply – 0x85 10
- Device Reply for Query Parameters– 0x84
- Camera Related Command – 0x28/0x65/0x26/0xAB
- Peripheral data info upload –0xA3
|
|
