L04-SE

L04-SE
Fabricante: Leencom

Número de unidades

4
ON-LINE
8
TOTAL
Supported in Wialon:
  • Modificação do parâmetro "velocidade"

The following data should also be added to L04-SE unit properties section of Wialon GPS tracking software :

Device type: L04-SE
ID único: custom

Specify the following parameters in configuration software or configuration L04-SE for use in Wialon Hosting :

Porta do servidor: 22491

8 units of L04-SE device type are connected to Wialon Data Center. This represents 0% of all AVL Hardware connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name Description Units
status_code

Report status: Status code
0x00 Upload in fixed time interval
0x14 Enter Geofence
0x15 Exit Geofence
0x1A Battery low power
0x1B Overspeed

gsm_signal_csq GSM Signal CSQ
content the command response content
acc ACC Status. ACC low: 0, ACC high: 1
mnc Mobile Network Code
status_reg_content Report status: Trigger content
alarm_status

Alarm status:
0: Normal
1: Shock Alarm
2: Power Cut Alarm
3: Low Battery Alarm
4: SOS

alarm

Alarm status:
0: normal
1: SOS
2: Power Cut Alarm
3: Vibration Alarm
4: Fence In Alarm
5: Fence Out Alarm
6: Over-speed Alarm
9: Moving Alarm

voltage

Voltage degree 0-6:
0: Lowest power and power off
1: No enough power to dial a call or send messages.
2: Low power and alarm
3: Lower power but can work normally
3~6: Work in good condition

battery Fuel level battery value
imei imei number
hdop HDOP
sequence_num Sequence Number
mileage Mileage statistics
status_trig_time1 Report status: Trigger time
temp Fuel temperature
gps_time_status GPS is Real Time or Reupload
rssi LBS Main Cell Tower, rssi
sensor_type

Sensor type:
0: BLE type;
1: RS485 type.

odometer Odometer
iccid iccid number
door Door status
gsm GSM signal strength degree
pwr_int Battery voltage(mV)
server_flag It refers to the data to send (by the coding format);
visible_sats Visible satellites
cell_id Cell Tower ID
battery_vol Battery Voltage
sats Number of satellites
imsi imsi number
time Time stamp
encoding

0X01: UTF-8
0x02: ASCII;

lac Location Area Code
mcc Mobile Country Code
boot_reason Boot Reason
inputs Input's Status, Bit 1-4: Door button status (1/0 Door Open/Close), Bit 5-8: Tamper button status (1/0 Removal/Installation) 0xff: Failed to get button status
sensor_percent Fuel level in percent
pwr_ext Voltage level

More devices from the manufacturer

Faça sua empresa crescer com a gente