GPS tracking protocol Think Power series

Features Think Power series:

Boîte à mémoire

Supported in Wialon:

Capteurs analogiques (ADC)
Données remontées du CANbus
Gestion à distance via GPRS
Capteurs numériques
Gestion à distance par SMS
Communication via TCP
Communication via UDP

The following data should also be added to Think Power series unit properties section of Wialon GPS tracking software :

Device type:	Think Power series
ID único:	imei

Specify the following parameters in configuration software or configuration Think Power series for use in Wialon Hosting :

Porta do servidor:

22711

0 units of Think Power series device type are connected to Wialon Data Center. This represents 0% of all Protocols and retranslators connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name	Description	Units
gps_st	GPS location alarm state: 0x00 = lost location 0x01 = location success
geo_fence	Geo-fence shape attribute: 1-byte 0x01 = circle 0x02 = rectangle 0x03 = polygon
geo_fence_id	Geo-fence ID number
geo_fence_evt	Geo-fence event: 0x01 = inside 0x02 = outside
acc_x	Accelerometer X-axis value	mG
acc_y	Accelerometer Y-axis value	mG
acc_z	Accelerometer Z-axis value	mG
g_sens_coll_alm	Collision alarm state: 0x00 = Not active 0x01 = Active
g_sens_drop_alm	Drop alarm state: 0x00 = Not active 0x01 = Active
g_sens_towed_alm	Towed away alarm state: 0x00 = Not active 0x01 = Active
rapid_dec_alm	Rapid deceleration alarm state: 0x00 = Not active 0x01 = Active
rapid_acc_alm	Rapid acceleration alarm state: 0x00 = Not active 0x01 = Active
pwr_int	Battery voltage	V
low_pwr_int_alm	Battery low battery alarm state: 0x00 = Not active 0x01 = Active
battery	Percentage of remaining battery	%
temp	Temperature	C
hum	Humidity	%
high_temp	High Temperature	C
high_hum	High Humidity	%
car_b_cut_alm	Car B+ cut alarm state: 0x00 = Not active 0x01 = Active
ign	Ignition input state: 0x00 = Not active 0x01 = Active
speeding_alm	Speeding alarm state: 0x00 = Not active 0x01 = Active
car_shrt_mileage	Car Short mileage value	km
shrt_drive_time	Short drive time value	min
fuel_lvl	Fuel level	%
ibutton	Driver identifier
mileage	Car total mileage	km
car_spd	Car speed	km/h
eng_load	Engine load
fuel_cons	Car short fuel consumption	L
tot_fuel_cons	Car total fuel consumption	L
eng_idl_work_tm	Car idle work time	h
eng_tot_work_tm	Car total work time	h
car_pwr_in	Car battery voltage	V
car_air_temp	Car air temperature	C
car_cool_temp	Car coolant temperature	%
car_cool_lvl	Car coolant level	%
oil_press	Car engine oil pressure level	kPa
car_acc_stat	Car ACC status:1-byte 0x00 = Not active 0x01 = Active
hold_time	Hold time	min
eng_spd	Engine speed	RPM
eng_hours	Elapsed Engine Hours	h
dist_last_v_coord	Distance Since Last Valid Coordinates	miles
malf_stat	Malfunction Indicator Status
data_diag_stat	Data Diagnostic Event Indicator Status
time_zone_offs_utc	Time Zone Offset from UTC
car_tot_work_tm	Car total work time:	h
theft_alm_state	Theft alarm state: 0x00 = Not active 0x01 = Active
light_alm	Light alarm state: 0x00 = Not active 0x01 = Active
door_alm	Door alarm state: 0x00 = Closed 0x01 = Open
tire_seq	Tire state by sequence
tire_comp	Tire Comparisions
tire_press	Tire Pressure	kPa
ble_id_X	ID of iBeacon
ble_rssi_X	Measured RSSI of BLE iBeacon
lbs_stat	LBS location state: 0x00 = lost location 0x01 = location success
csq	CSQ of cellular network