Globalstar SmartOne

These bits reflect the state of the inputs and indicate which one, if any, triggered an Input Status Changed message.
Bit 0: Input 1 change: 0 = Did not trigger message, 1 = Triggered message.
Bit 1: Input 1 state: 0 = Closed, 1 = Open
Bit 2: Input 2 change: 0 = Did not trigger message, 1 = Triggered message
Bit 3: Input 2 state: 0 = Closed, 1 = Open
Bits (7:4) message sub-type code. See subtypes below: Value is 0 in the location message. Value is 1 in the Device Turned On message. Value is 2 in the Change of Location Area alert message.
Value is 3 in the Input Status Changed message. Value is 4 in the undesired input state message. Value is 5 in the re-centering message.

Bits (7:4) message sub-type code. See subtypes below: Value is 0 in the location message. Value is 1 in the Device Turned On message. Value is 2 in the Change of Location Area alert message.
Value is 3 in the Input Status Changed message. Value is 4 in the undesired input state message. Value is 5 in the re-centering message.
(this parameter has the same information as the second half of the alarm)

Bit (2) 0 = Good battery. 1 = replace battery.
Bit (3) 0 = GPS Data valid in this message. 1 = GPS failed in this message cycle, ignore Latitude and Longitude fields.
Bit (4) Missed Input 1. A value of 1 in this bit means that an input state change of input 1 was missed due to the transmission of a higher priority message.
Bit (5) = Missed Input 2. A value of 1 in this bit means that an input state change of Input 2 was misse
Bit (7:6) = GPS fail counter. Counts up to a maximum value of 3 upon GPS failure.