Personal GPS tracker Prime AT NG | Integrated with Wialon

Features Prime AT NG:

Caixa preta
Posicionamento Wi-Fi

The following data should also be added to Prime AT NG unit properties section of Wialon GPS tracking software :

Device type:	Prime AT NG
ID único:	imei

Specify the following parameters in configuration software or configuration Prime AT NG for use in Wialon Hosting :

Porta do servidor:

22187

240 units of Prime AT NG device type are connected to Wialon Data Center. This represents 1.27% of all Personal trackers connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name	Description	Units
gps_acc	GPS accuracy
battery	The current volume of the backup battery	%
rep_type	Type of report: Type of the report: FRI - Fixed Report Information GEO - Geo-Fence Information SPD - Speed Alarm SOS - SOS report RTO - Real Time Operation PNL - The first location after the device powers on NMR - Non movement is detected by motion sensor DIS - The status of digital input is detected being changed HIS - History report INF - Device Information Report WIF - WLAN Information Report GPS - The report for real time operation GPS CID - The report for real time operation CID CSQ - The report for real time operation CSQ VER - The report for real time operation VER PNA - Power on report PFA - Power off report EPN - The report for connecting external power supply EPF - The report for disconnecting external power supply BPL - Battery low report BTC - Start charging report STC - Stop charging report STT - Device motion state indication PDP - Mobile Data Service PDP connect report SWG - Switch on or off Geo-Fence 0 via function key GSM - The report for the information of the service cell and the neighbor cells. GSI - G-sensor Information Report
inputN	The current logical status of the input port number N: 0 - is disable status 1 - is enable status
power_percent	The current volume of the backup battery	%
iccid	The ICCID of the SIM card
temp	The temperature of the Device	°C
lightness	The lightness level
pwr_int	The voltage of the battery	V
csq_rssi	The GSM signal strength level. The range is 0-31, 99 for unknown
csq_ber	The quality of the GSM signal. The range is 0-7, 99 for unknown
dev_type	The type of device
sw_ver	The software version
hw_ver	The hardware version
is_pwr_ext	Whether the external power supply is connected. 0 - not connected 1 - connected
charging	Whether the backup battery is charging when the main power supply is connected. 0 - not charging 1 - charging
led_on	Indicate whether the LED’s are turned on
light_state	The lightness state: 0: Report after the GPS fixing finished of timeout. 1: Lightness is greater than the bright threshold (Device from dark place to light place). 2: Lightness is less than the dark threshold (Device from light place to dark place).
mcc	Mobile country code
mnc	Mobile network code
lac	Location area code
cell_id	Cell ID
pwr_ext_flg	Whether the external power supply is connected: 0 - Not connected 1 - Connected
gps_on_need	GPS on need
gps_antenna_type	GPS antenna type
rep_id	Report id
geo_mode	Geo mode
geo_radius	Geo radius
geo_check_int	Geo check int
ble_mac_#	Ble MAC address
hum	Humidity
gps_antenna_state	GPS antenna state
wifi_mac_#	WiFi MAC
wifi_rssi_#	WiFi RSSI
gps_fix_delay	GPS fix delay
mask_report	mask_report
mask_fri	Mask FRI packet
geo_active	Geo active
fix_type	FIX type
fota_upd_stat	Fota update status
mod_ver	Module version
ble_num	Ble number of sensors
ble_uuid_#	Ble uuid
ble_major_#	Ble major
ble_minor_#	Ble minor
ble_rssi_#	Ble rssi
ble_raw_#	Ble raw data

Parameter name

Description

Units

gps_acc

GPS accuracy

battery

The current volume of the backup battery

rep_type

Type of report:
Type of the report:
FRI - Fixed Report Information
GEO - Geo-Fence Information
SPD - Speed Alarm
SOS - SOS report
RTO - Real Time Operation
PNL - The first location after the device powers on
NMR - Non movement is detected by motion sensor
DIS - The status of digital input is detected being changed
HIS - History report
INF - Device Information Report
WIF - WLAN Information Report
GPS - The report for real time operation GPS
CID - The report for real time operation CID
CSQ - The report for real time operation CSQ
VER - The report for real time operation VER
PNA - Power on report
PFA - Power off report
EPN - The report for connecting external power supply
EPF - The report for disconnecting external power supply
BPL - Battery low report
BTC - Start charging report
STC - Stop charging report
STT - Device motion state indication
PDP - Mobile Data Service PDP connect report
SWG - Switch on or off Geo-Fence 0 via function key
GSM - The report for the information of the service cell and the neighbor cells.
GSI - G-sensor Information Report

inputN

The current logical status of the input port number N:
0 - is disable status
1 - is enable status

power_percent

The current volume of the backup battery

iccid

The ICCID of the SIM card

temp

The temperature of the Device

°C

lightness

The lightness level

pwr_int

The voltage of the battery

csq_rssi

The GSM signal strength level. The range is 0-31, 99 for unknown

csq_ber

The quality of the GSM signal. The range is 0-7, 99 for unknown

dev_type

The type of device

sw_ver

The software version

hw_ver

The hardware version

is_pwr_ext

Whether the external power supply is connected.
0 - not connected
1 - connected

charging

Whether the backup battery is charging when the main power supply is connected.
0 - not charging
1 - charging

led_on

Indicate whether the LED’s are turned on

light_state

The lightness state:
0: Report after the GPS fixing finished of timeout.
1: Lightness is greater than the bright threshold (Device from dark place to light place).
2: Lightness is less than the dark threshold (Device from light place to dark place).

mcc

Mobile country code

mnc

Mobile network code

lac

Location area code

cell_id

Cell ID

pwr_ext_flg

Whether the external power supply is connected:
0 - Not connected
1 - Connected

gps_on_need

GPS on need