Видеоустройство Queclink CV5000 | Интегрирован с Wialon

Особенности Queclink CV5000:

4G/LTE
ADAS
Наличие черного ящика
BLE enabled
DMS

Поддержано в Wialon:

Акселерометр
Сохранение файлов по событиям
Управляющие команды по GPRS
Трансляция онлайн
Сохранение из накопителя вручную
Трансляция записи
Управляющие команды по SMS
Связь через TCP

Для того чтобы система мониторинга Wialon корректно идентифицировала данные от Queclink CV5000 в диалоге настроек объекта, укажите следующие данные :

Тип устройства:	Queclink CV5000
Уникальный ID:	imei

Укажите следующие параметры в конфигурационной программе или в конфигурации Queclink CV5000 для использования его в Wialon Hosting :

Порт сервера:

22889

Всего в серверном центре Wialon используется 20 объектов Queclink CV5000 — это составляет 0.03% от общего количества устройств в категории «Видео мониторинг».

График изменения количества подключений в серверном центре Wialon за последние 30 дней:

Имя параметра	Описание	Единицы измерения
adc1	Analog Input 1 voltage
pwr_ext	External power source voltage
proto_ver	Queclink protocol version *HEX mode only
motion_status	17 (0x11) Ignition off Rest: The vehicle is ignition off and motionless. 18 (0x12) Ignition off Motion: The vehicle had been moving before this action was regarded as car-towing event after ignition off. 33 (0x21) Ignition On Rest: The vehicle is ignition on and motionless. 34 (0x22) Ignition On Motion: The device is ignition on and moving.
curr_hourmetercount	Current Trip Hour Meter Count (accumulative ignition time) *HEX mode only
din_status	Digital Input (bit mask)
bt_bat_level	The voltage of Bluetooth accessory
fw_ver	Firmware version *HEX mode only
dev_type	Queclink device type *HEX mode only
adc_mode	Analog Input Mode
bt_status	0 - the accessory is not available 1 - the accessory is available
battery	Battery level, 0-100
bt_temp	Temperature data fo Bluetooth accessory
curr_mileage	Current Trip Mileage *HEX mode only
dout_status	Digital Output (bit mask)
total_mileage	Total Mileage *HEX mode only
event_id	Events of driver safety system (ADAS and DMS). Reports in GTDSS packet with the following values: 1 - Eye Close 2 - Yawling 3 - Distraction 4 - Smoking 5 - Phone Use 6 - Drive abnormal 7 - IR blocking 8 - Seatbelt unfastened 20 - Forward collision warning 21 - Pedestrian collision warning 22 - Headway monitoring warning
csq_ber	CSQ BER,0-7/99
total_hourmetercount	Total Hour Meter Count (accumulative ignition time) *HEX mode only
pwr_s	whether the external power supply is connected.
ledon	1 - Cell LED anf GNSS LED turn on as configured 2 - Both LEDs work 10 minutes after tge device is powered on and then will be off.
indx	The index of Bluetooth accessory defined in AT+GTBAS which triggers the +RESP:GTBAA message 0xFF for WKF300
alarm_type	0 - the voltage of the Bluetooth accessory is low 1 - the temperature alarm: current temperature value is below 2 - the temperature alarm: current temperature value is upper 3 - the temperature alarm: current temperature value is within the range defined by <low temperature> and <high temperature> 4 - Push button event on WKF300 is detected
csq_rssi	the level of signal strength
bt_name	Bluetooth accessory name
acbe_model	The model of the bluetooth accessory
id_reptype	The ID is unauthorized or the ID authorization (IDA) function is disabled; The ID is authorized
acces_type	0 - No bluetooth accessory 1 - Reserved 2 - Beacon temperature sensor 3 - BLE beacon ID device
id	The ID which is currently read
charging	Wheter the backup battery is charging when the main power supply is connected
can_eng_torgue	Engine Torgue
bt_mac	Bluetooth accessory mac
pwr_int	pwr int
upc_result	upc result
jamming_cw	jamming cw
temp_device_id	temp device id
z_side	z side
mcu_ver	mcu ver
upd_retry	upd retry
x_forward	x forward
wave1_out_id	wave1 out id
upd_code	upd code
resp_report_mask	resp report mask
geo_id	geo id
fuel_sensor[i]_percent	fuel sensor[i] percent
y_forward	y forward
z_vert	z vert
sat_[sv_id]	sat [sv id]
jamming_gps	jamming gps
ibutton	ibutton
x_vert	x vert
x_side	x side
fuel_sensor[i]_type	fuel sensor[i] type
hw_ver	hw ver
gps_signal_status	gps signal status
z_forward	z forward
crash_counter	crash counter
y_vert	y vert
fuel_sensor[i]_id	fuel sensor[i] id
geo_area_mask_group_2	geo area mask group 2
onewire[i]_type	onewire[i] type
gps_level	gps level
sms_cmd_count	sms cmd count
rx_level[i]	rx level[i]
sms_msg_count_white	sms msg count white
roaming_state	roaming state
cell_id[i]	cell id[i]
url	url
ign_dur	ign dur
geo_area_mask_group_1	geo area mask group 1
fuel_sensor[i]_volume	fuel sensor[i] volume
temp_alarm_id	temp alarm id
udp_cmd_count	udp cmd count
upc_cmd_id	upc cmd id
onewire[i]_data	onewire[i] data
onewire[i]_id	onewire[i] id
udp_msg_count	udp msg count
mnc[i]	mnc[i]
ges_mode	ges mode
geo_area_type	geo area type
jamming_indicator	jamming indicator
phone_number	phone number
fri_discard_no_fix	fri discard no fix
geo_mask_group	geo mask group
gir_trigger	gir trigger
idle_dt	idle dt
time_zone	time zone
iccid	iccid
ges_enabled	ges enabled
tcp_msg_count	tcp msg count
ign_dt	ign dt
jamming_status	jamming status
ges_radius	ges radius
y_side	y side
local_ip	local ip
ta[i]	ta[i]
wave1_out_active	wave1 out active
sms_msg_count	sms msg count
ges_dt	ges dt
ibutton_auth	ibutton auth
bat_status	bat status
temp_status	temp status
igf_dt	igf dt
daylight_saving	daylight saving
tcp_cmd_count	tcp cmd count
lac[i]	lac[i]
sms_cmd_count_white	sms cmd count white
temp_device_data	temp device data

Имя параметра

Описание

Единицы измерения

adc1

Analog Input 1 voltage

pwr_ext

External power source voltage

proto_ver

Queclink protocol version
*HEX mode only

motion_status

17 (0x11) Ignition off Rest: The vehicle is ignition off and motionless.

18 (0x12) Ignition off Motion: The vehicle had been moving before this action was regarded as car-towing event after ignition off.

33 (0x21) Ignition On Rest: The vehicle is ignition on and motionless.

34 (0x22) Ignition On Motion: The device is ignition on and moving.

curr_hourmetercount

Current Trip Hour Meter Count (accumulative ignition time)
*HEX mode only

din_status

Digital Input (bit mask)

bt_bat_level

The voltage of Bluetooth accessory

fw_ver

Firmware version
*HEX mode only

dev_type

Queclink device type
*HEX mode only

adc_mode

Analog Input Mode

bt_status

0 - the accessory is not available
1 - the accessory is available

battery

Battery level, 0-100

bt_temp

Temperature data fo Bluetooth accessory

curr_mileage

Current Trip Mileage
*HEX mode only

dout_status

Digital Output (bit mask)

total_mileage

Total Mileage
*HEX mode only

event_id

Events of driver safety system (ADAS and DMS).
Reports in GTDSS packet with the following values:

1 - Eye Close
2 - Yawling
3 - Distraction
4 - Smoking
5 - Phone Use
6 - Drive abnormal
7 - IR blocking
8 - Seatbelt unfastened
20 - Forward collision warning
21 - Pedestrian collision warning
22 - Headway monitoring warning

csq_ber

CSQ BER,0-7/99

total_hourmetercount

Total Hour Meter Count (accumulative ignition time)
*HEX mode only

pwr_s

whether the external power supply is connected.

ledon

1 - Cell LED anf GNSS LED turn on as configured
2 - Both LEDs work 10 minutes after tge device is powered on and then will be off.

indx

The index of Bluetooth accessory defined in AT+GTBAS which triggers the +RESP:GTBAA message
0xFF for WKF300

alarm_type

0 - the voltage of the Bluetooth accessory is low
1 - the temperature alarm: current temperature value is below
2 - the temperature alarm: current temperature value is upper
3 - the temperature alarm: current temperature value is within the range defined by <low temperature> and <high temperature>
4 - Push button event on WKF300 is detected

csq_rssi

the level of signal strength

bt_name

Bluetooth accessory name

acbe_model

The model of the bluetooth accessory

id_reptype