Queclink GL300W

RESP
BUFF
ACK

0 - not buffered message
1 - buffered message

Report ID.
For GEO:
it indicates the ID of the Geo-Fence.
For FRI:
it indicates the <Append Mask>.
For SOS:
0: Triggered through other ways.
1: Triggered by input ID 1.
For HBM:
“3” indicates high speed,
“2” indicates medium speed
“1” indicates low speed.

Report Type.
For FRI
0: This message is a common scheduled position report.
1: This message is a turning point.
For GEO
0: Exit the corresponding Geo-fence.
1: Enter the corresponding Geo-fence.
For SPD
0: Outside the speed range.
1: Inside the speed range.
For NMR
0: The state of the device changes from motion to rest.
1: The state of the device changes from rest to motion.
For DIS
0: The current logic status of the input port is low level.
1: The current logic status of the input port is high level.
For IGL
0: The engine is ignition on.
1: The engine is ignition off.
For DOG
0: Reboot periodically according to the <Interval> and <Time> settings or upon ignitionon or by <Input ID>
1: PDP is unable to register successfully or the interaction of messages fails
2: No WCDMA signal
For HBM
0: Harsh braking behavior
1: Harsh acceleration behavior