Localizador GPS personal Queclink GL300

Características Queclink GL300:

Caja negra
Soporta GLONASS

Soportado en Wialon:

Gestión remota vía GPRS
LBS
Gestión remota vía SMS
Comunicación vía TCP
Comunicación por UDP

Para que el sistema de rastreo Wialon identifique los datos de Queclink GL300 en el diálogo de configuración de la unidad, indique los siguientes datos :

Tipo de dispositivo:	Queclink GL300
ID único:	imei

Indique los siguientes parámetros en el programa de configuración o en la configuración Queclink GL300 para utilizarlos en Wialon Hosting :

Puerto del servidor:

20706

En el centro de servicio Wialon se utilizan 1218 unidades Queclink GL300 — es 5.86% de la cantidad total de dispositivos Personal conectados.

La gráfica representa la cantidad de conexiones en el centro de servicio Wialon en los últimos 30 días:

Nombre del parámetro	Descripción	Unidades de medida
battery	Battery level	%
ber	The quality of GSM signal
charger	Whether the battery is charging when the external power supply is connected: 0: Not charging 1: Charging
charging	Whether the battery is charging when the external power supply is connected: 0: Not charging 1: Charging
external_pwr	External power supply: 0: Not connected 1: Connected
flash_type	A numeric to indicate what the type of flash is: 0: SST flash 1: NMX flash
gps_antenna_type	A numeric to indicate which GPS antenna is working now 0: inside GPS antenna
gps_on_need	Whether to close GPS chip after retrieving GPS position information: 0: Never close GPS chip 1: Close GPS chip after retrieving GPS information every time 2: Never close GPS chip only in ignition on state or movement state 3: Never open GPS chip
gsm_level	The GSM signal strength level
gsm_quality	The quality of GSM signal
hdop	Horizontal Dilution of Precision
ign	Ignition state: 0: off, 1: on
ign_off_duration	Duration since last time the ignition is off	s
ign_on_duration	Duration since last time the ignition is on	s
led_on	The working mode of LEDs
mileage	The total mileage	km
movement_cause	The enter movement cause defines the factor who triggers the message: 0: Triggered by motion sensor detection. It is defaulted 1: Triggered by RTO sub command RTL 2: Triggered by the command GTLSW from EBK
movement_state	0: The state of the device changed from motion to rest 1: The state of the device changed from rest to motion
odo_mileage	The total mileage in the position	km
pwr_int	Battery voltage	V
report_type	Message type
rssi	The GSM signal strength level
state	The current motion state of the device: 21: The device attached vehicle is ignition on and motionless 22: The device attached vehicle is ignition on and moving 41: The device is motionless without ignition on 42: The device is moving without ignition on
temp_int	The temperature of the device	°C
geo_mode	The new mode of Geo-Fence
geo_radius	The radius of Geo-Fence	m
geo_ch_int	The check interval of Geo-Fence	sec
geo_active	Indicate active or deactive Geo-Fence: 0 - Deactivate Geo-Fence 1 - Activate Geo-Fence