Personal GPS tracker Queclink GL300 | Integrated with Wialon

Features Queclink GL300:

Caixa preta
Suporte GLONASS

Supported in Wialon:

Gerenciamento remoto via GPRS
LBS
Gerenciamento remoto via SMS
Comunicação via TCP
Comunicação via UDP

The following data should also be added to Queclink GL300 unit properties section of Wialon GPS tracking software :

Device type:	Queclink GL300
ID único:	imei

Specify the following parameters in configuration software or configuration Queclink GL300 for use in Wialon Hosting :

Porta do servidor:

20706

1222 units of Queclink GL300 device type are connected to Wialon Data Center. This represents 5.87% of all Personal trackers connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name	Description	Units
battery	Battery level	%
ber	The quality of GSM signal
charger	Whether the battery is charging when the external power supply is connected: 0: Not charging 1: Charging
charging	Whether the battery is charging when the external power supply is connected: 0: Not charging 1: Charging
external_pwr	External power supply: 0: Not connected 1: Connected
flash_type	A numeric to indicate what the type of flash is: 0: SST flash 1: NMX flash
gps_antenna_type	A numeric to indicate which GPS antenna is working now 0: inside GPS antenna
gps_on_need	Whether to close GPS chip after retrieving GPS position information: 0: Never close GPS chip 1: Close GPS chip after retrieving GPS information every time 2: Never close GPS chip only in ignition on state or movement state 3: Never open GPS chip
gsm_level	The GSM signal strength level
gsm_quality	The quality of GSM signal
hdop	Horizontal Dilution of Precision
ign	Ignition state: 0: off, 1: on
ign_off_duration	Duration since last time the ignition is off	s
ign_on_duration	Duration since last time the ignition is on	s
led_on	The working mode of LEDs
mileage	The total mileage	km
movement_cause	The enter movement cause defines the factor who triggers the message: 0: Triggered by motion sensor detection. It is defaulted 1: Triggered by RTO sub command RTL 2: Triggered by the command GTLSW from EBK
movement_state	0: The state of the device changed from motion to rest 1: The state of the device changed from rest to motion
odo_mileage	The total mileage in the position	km
pwr_int	Battery voltage	V
report_type	Message type
rssi	The GSM signal strength level
state	The current motion state of the device: 21: The device attached vehicle is ignition on and motionless 22: The device attached vehicle is ignition on and moving 41: The device is motionless without ignition on 42: The device is moving without ignition on
temp_int	The temperature of the device	°C
geo_mode	The new mode of Geo-Fence
geo_radius	The radius of Geo-Fence	m
geo_ch_int	The check interval of Geo-Fence	sec
geo_active	Indicate active or deactive Geo-Fence: 0 - Deactivate Geo-Fence 1 - Activate Geo-Fence