Traceur GPS personnel Queclink GL300

Caractéristiques Queclink GL300:

Boîte à mémoire
Compatibilité avec GLONASS

Compatible avec Wialon:

Gestion à distance via GPRS
LBS
Gestion à distance via SMS
Communication via TCP
Communication via UDP

Afin d'identifier le boîtier Queclink GL300 les détails suivants sont à utiliser dans les réglages de l'unité sur Wialon :

Type du boîtier GPS:	Queclink GL300
ID unique:	imei

Précisez les paramètres suivants dans le programme de configuration ou dans la configuration Queclink GL300 pour les utiliser dans Wialon Hosting :

Port du serveur:

20706

1282 unités Queclink GL300 connectées au le centre de données Wialon — Ça fait 6.07% de nombre total des boîtiers GPS connectés.

Le diagramme ci-dessous représente la dynamique des connexions dans le centre de données Wialon au cours des 30 derniers jours:

Nom du paramètre	Description	Unités
battery	Battery level	%
ber	The quality of GSM signal
charger	Whether the battery is charging when the external power supply is connected: 0: Not charging 1: Charging
charging	Whether the battery is charging when the external power supply is connected: 0: Not charging 1: Charging
external_pwr	External power supply: 0: Not connected 1: Connected
flash_type	A numeric to indicate what the type of flash is: 0: SST flash 1: NMX flash
gps_antenna_type	A numeric to indicate which GPS antenna is working now 0: inside GPS antenna
gps_on_need	Whether to close GPS chip after retrieving GPS position information: 0: Never close GPS chip 1: Close GPS chip after retrieving GPS information every time 2: Never close GPS chip only in ignition on state or movement state 3: Never open GPS chip
gsm_level	The GSM signal strength level
gsm_quality	The quality of GSM signal
hdop	Horizontal Dilution of Precision
ign	Ignition state: 0: off, 1: on
ign_off_duration	Duration since last time the ignition is off	s
ign_on_duration	Duration since last time the ignition is on	s
led_on	The working mode of LEDs
mileage	The total mileage	km
movement_cause	The enter movement cause defines the factor who triggers the message: 0: Triggered by motion sensor detection. It is defaulted 1: Triggered by RTO sub command RTL 2: Triggered by the command GTLSW from EBK
movement_state	0: The state of the device changed from motion to rest 1: The state of the device changed from rest to motion
odo_mileage	The total mileage in the position	km
pwr_int	Battery voltage	V
report_type	Message type
rssi	The GSM signal strength level
state	The current motion state of the device: 21: The device attached vehicle is ignition on and motionless 22: The device attached vehicle is ignition on and moving 41: The device is motionless without ignition on 42: The device is moving without ignition on
temp_int	The temperature of the device	°C
geo_mode	The new mode of Geo-Fence
geo_radius	The radius of Geo-Fence	m
geo_ch_int	The check interval of Geo-Fence	sec
geo_active	Indicate active or deactive Geo-Fence: 0 - Deactivate Geo-Fence 1 - Activate Geo-Fence