Asset GPS tracker Tetis | Integrated with Wialon

Features Tetis:

E-seal
Magnetic mounting

Supported in Wialon:

SMS sending of data
Communication via UDP

The following data should also be added to Tetis unit properties section of Wialon GPS tracking software :

Device type:	Tetis
Unique ID:	serial

Specify the following parameters in configuration software or configuration Tetis for use in Wialon Hosting :

Server port:

20854

0 units of Tetis device type are connected to Wialon Data Center. This represents 0% of all Asset trackers connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name	Description	Units
arm	Arm input state
blinker	Blinker output state
disarm	Disarm input state
door	Door input state
emergency	Emergency input state
engine_rpm	Engine RPM	rpm
eventid	Event ID in case of a custom event
fuel	Special algorithm for an analog input
gps_connected	GPS device on/off
gps_valid	GPS actual validity
gradualstop	Gradualstop output state
hood	Hood input state
ign	Ignition input state
immobilizer	Immobilizer output state
int_lights	Int_lights output state
kind	Type of packet
lock	Lock output state
logic_state	Logic states
mileage	Kilometers counter	km
odometer	Odometer reading
pending	If this value is '0' it means that no older messages than datetime_actual are left in the unit's memory
pwr_ext	Input voltage	V
pwr_int	Battery level	%
reason	0 - No Reason Recorded 1 - Response 2 - Tracking 4 - Custom Event 5 - Deinstalled 6 - Installed 7 - Main Power Low 8 - Door Opened 9 - Door Closed 10 - Strong Impact 11 - Button Off 12 - Button On 13 - Weak Impact 14 - Location Update 29 - Power On 30 - Light Off 31 - Light On 32 - Temperature low 35 - Humidity low 33 - Temperature high 36 - Humidity high 37 - Jamming 38 - Logging 40 - Temperature normal 41 - Humidity normal
response	If the packet is a response to an incoming command value is 1
shock	Shock input state
siren	Siren output state
software_version	Firmware version
trunk	Trunk output state
unittype	Unit type (0 - LCU500, 5 - Helios)
unlock	Unlock output state
volume	Volume input state

All Starcom devices use encrypted protocol and can't send data to Wialon directly. Customer should use special Starcom Routing Software on dedicated server. Please ask Starcom support about it.

Fill out a request form to get started with Wialon

Products

Niche products for addressing specific tasks

Tetis

More devices from the manufacturer

Contact Wialon and achieve the most ambitious goals with telematics

Become a partner

Request Wialon in your region

Fill out a request form to get started with Wialon