Astra AT202

Astra AT202
Manufacturer: Astra Telematics
Forum Discussion

Number of units

0
Online
0
Total
Features Astra AT202:
  • 2G
  • 4G/LTE
  • Blackbox

The following data should also be added to Astra AT202 unit properties section of Wialon GPS tracking software :

Device type: Astra AT202
Unique ID: custom

Specify the following parameters in configuration software or configuration Astra AT202 for use in Wialon Hosting :

Server port: 22382

0 units of Astra AT202 device type are connected to Wialon Data Center. This represents 0% of all AVL Hardware connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name Description Units
pwr_ext

external input voltage

V
battery

internal back-up battery level

V
gps_time

gps time/date, last known good

seconds since 01.01.1970
max_speed

maximum speed since last report

km/h
journey_distance

distance travelled during a journey

km
inputs

state of digital inputs

bit 0 - digital input 1

bit 1 - digital input 2

bit 2 - digital input 3

bit 3 - digital input 4

bit 4 - digital input 5

bit 5 - digital input 6

etc.


(not set)
outputs

bit 0 - digital output 1

bit 1 - digital output 2

bit 2 - digital output 3

bit 3 - digital output 4

bit 4 - digital output 5

etc.

(not set)
digital_change_mask

indicates which digital inputs (low byte) and outputs (high byte) have changed state since the last report

bit 0 - digital input 1 change

bit 1 - digital input 2 change

bit 2 - digital input 3 change

bit 3 - digital input 4 change

bit 4 - digital input 5 change

bit 5 - digital input 6 change

etc.

bit 8 - digital output 1 change

bit 9 - digital output 2 change

bit 10 - digital output 3 change

bit 11 - digital output 4 change

bit 12 - digital output 5 change

bit 13 - digital output 6 change

etc.

(not set)
adc1

ADC1 input current value

(not set)
adc2

ADC2 input current value

(not set)
accel_x_max

accel X max since last report

g
accel_x_min

accel X min since last report

g
accel_y_max

accel Y max since last report

g
accel_y_min

accel Y min since last report

g
accel_z_max

accel Z max since last report

g
accel_z_min

accel Z min since last report

g
idle

idle time for the current journey in seconds

seconds
wln_accel_max

Maximum acceleration for the period

g
wln_brk_max

Maximum deceleration per period

g
wln_crn_max

lateral acceleration (modulo)

g
signal_strength

GSM signal strength

GSM LEVELS:

0 -111 dBm or less

1 -109dBm

2 -105dBm

3 -101dBm

4 -97dBm

5 -93dBm

6 -89dBm

7 -85dBm

8 -81dBm

9 -77dBm

10 -73dBm

11 -69dBm

12 -65dBm

13 -61dBm

14 -57dBm

15 -53dBm

(not set)
mcc

GSM mobile network country code

(not set)
mnc

GSM mobile network operator code

(not set)
driver_type

source of driver ID data:

0 None

1 iButton

2 External RFID/NFC card reader

3 Bluetooth

(not set)
driver_id

Driver ID serial number


(not set)
odometer

lifetime odometer km

km
engine_hours

engine running hours

hours
iccid

SIM ICCID

(not set)
model

device model

(not set)
vin

vehicle VIN (CANBus only)

(not set)
sf_ver

device firmware version

(not set)
protocol

device protocol ID

(not set)
hw_ver

device hardware version

(not set)
reason_flags

this bitmask defines the event or events which triggered the report. Note that multiple reason bits can occur, so bitwise handling is essential

bit 0 Timed interval elapsed

bit 1 Distance travelled exceeded

bit 2 Position on demand (i.e. polled)

bit 3 Geofence event

bit 4 Panic switch activated

bit 5 External input/output event

bit 6 Journey START

bit 7 Journey STOP

bit 8 Heading change

bit 9 Low battery

bit 10 External power event

bit 11 Idling start event

bit 12 Idling end event

bit 13 Idling ongoing

bit 14 Power ON or RESTART event

bit 15 Speed overthreshold

bit 16 Towing event (vehicle moving with IGN off)

bit 17 Unauthorised driver alarm (vehicle IGN on and unknown driver)

bit 18 Collision alarm (excessive G forces detected)

bit 19 Accel threshold maximum event (positive X axis)

bit 20 Cornering threshold maximum event (Y axis)

bit 21 Decel threshold maximum event (negative X axis)

bit 22 GPS re-acquired

bit 23 CANBus event

bit 24 CARRIER event

bit 25 TAMPER alarm

bit 26 Towing event end

bit 27 Serial device event (change of status)

bit 28 Low External Voltage (based on CPWR threshold)

bit 29 Entering sleep mode

bit 30 Bike fall / vehicle roll-over

bit 31 Motion detected (whilst parked / out of journey)

(not set)
status_flags

this bitmask defines the device status at the time of the event. Note that multiple status bits can occur, so bitwise handling is essential

bit 0 Ignition status ON (ign OFF when this bit is zero)

bit 1 Business / Private mode (0 = business, 1 = private)

bit 2 GPS invalid (0 = valid, 1 = invalid)

bit 3 Network roaming (0 = home network, 1 = roaming)

bit 4 Reports to follow

bit 5 Stored/Live report (1 = stored, 0 = live)

bit 6 Immobiliser current state (1 = immobilsed, 0 = not immobilised)

bit 7 RS232 external device read error

bit 8 GPS jammer detected (0 = no jammer, 1 = jammer detected)

bit 9 Luggage compartment / topcase state (0 = unlocked, 1 = locked)

bit 10 Back-up battery status (0 = not charging, 1 = charging)

bit 11 RESERVED

bit 12 RESERVED

bit 13 RESERVED

bit 14 RESERVED

bit 15 RESERVED

(not set)

More devices from the manufacturer

Contact Wialon and achieve the most ambitious goals with telematics

Fill out a request form to get started with Wialon

Step 1
Step 2
Step 3
First name*
Last name*
Company*
Email*
Phone