Xexun TK-102

Number of units

20
Online
47
Total
Supported in Wialon:
  • ADC sensors
  • Remote management via GPRS
  • Digital sensors
  • SMS sending of data
  • Remote management via SMS
  • Alarm button
  • Communication via TCP

The following data should also be added to Xexun TK-102 unit properties section of Wialon GPS tracking software :

Device type: Xexun TK-102
Unique ID: imei

Specify the following parameters in configuration software or configuration Xexun TK-102 for use in Wialon Hosting :

Server port: 20157

47 units of Xexun TK-102 device type are connected to Wialon Data Center. This represents 0.22% of all Personal trackers connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name Description Units
ac_alarm Acceleration alarm
acc_alarm Acceleration alarm
battery Battery charge level %
door_alarm Door alarm
door Door alarm
event Event that initiated the message
fortify Fortification alarm
fuel_level Fuel level %
help_me SOS button pressed
ign Ignition on/off
ignition Ignition on/off
low_battery Low battery alarm
move_alarm Movement alarm
over_speed Over speed alarm
param_1 Additional param 1 value
param_2 Additional param 2 value
power_fail External power failure
pwr_int Internal battery voltage Volt
rfid RFID
shake Shake alarm
temp Temperature °C
trigger Trigger alarm


In order to configure the object, you have to follow these steps by sending SMS commands to the tracker:

  • "begin123456" - resets all controller's settings, password 123456 is set by default
  • make a call to the controller, which should wait until two beeps, break the call and send SMS with it's coordinates
  • "apn123456 mts" - sets the required apn for gprs configuration
  • "apnuser123456 mts" - sets the user for gprs configuration
  • "apnpasswd123456 mts" - sets the password for gprs configuration. For new equipment versions user and password are set with one command "admin123456 mts mts"
  • "GPRS123456" - we're setting GPRS mode
  • "adminip123456 <IP> 20157" - sets the server's address for packages sending, <IP> replace for IP of monitoring system
  • "t030s***n123456" - sets the interval of messages sending to 30 seconds.

More devices from the manufacturer

Contact Wialon and achieve the most ambitious goals with telematics

Fill out a request form to get started with Wialon

Step 1
Step 2
Step 3
First name*
Last name*
Company*
Email*
Phone