GPS tracker JX11 | Integrated with Wialon

Features JX11:

2G
4G/LTE
Blackbox

The following data should also be added to JX11 unit properties section of Wialon GPS tracking software :

Device type:	JX11
Unique ID:	custom

Specify the following parameters in configuration software or configuration JX11 for use in Wialon Hosting :

Server port:

22395

2 units of JX11 device type are connected to Wialon Data Center. This represents 0% of all AVL Hardware connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name	Description	Units
param_id_#	Parameter value
uart_msg_mode	UART message mode
uart_msg_datatype	UART message datatype 0=ASCII, 1=BIN
uart_msg_data	UART message data
alarm_flag	0,2,3,5,6,9-14,17-27,29,30: Reserved the default as 0 Bit 1: Overspeed alarm Bit 4: GNSS fault Bit 7: Device main power under voltage Bit 8: Device main power off Bit 15: Remove alarm Bit 16: Vibration alarm Bit 28: Illegal displacement of the vehicle Bit 31: Reserved
state_flag	4-30: Reserved default is 0 Bit 0: 0-ACC off 1-ACC on Bit 1: 0-GNSS position unfix 1-GNSS position fix Bit 2: 0-north latitude 1-south latitude Bit 3: 0-east longitude 1-west longitude Bit 10: 0-fuel connect 1-fuel disconnect Bit 30: 0-normal data 1-TOW data Bit 31: 0-real time data 1-buffer data
odometer	Odometer
gsm	Mobile Network Signal Strength
pwr_ext	External supply voltage in mV	mV
fw_ver	Firmware version
bt_mac_#	Bluetooth MAC
bt_rssi_#	Bluetooth RSSI
bt_name_#	Bluetooth name
bt_fw_ver_#	Bluetooth firmware version
bt_volt_#	Bluetooth voltage
bt_temp_#	Bluetooth temperature
bt_hum_#	Bluetooth humidity
bt_sens_#	Bluetooth sensor (X,Y,Z)
wifi_mac_#	WIFI MAC
wifi_rssi_#	WIFI RSSI
gpio_ch_#	GPIO channel
gpio_st_#	GPIO status
data_type	Data type(0-63 is for GA series, 64-255 is for V series )： V series: 64:periodic trigger 65:power on trigger 66:ACC ignition 67:ACC flameout 68:VCC connect 69:VCC remove 70:virtual ignition(Gsensor) 71:virtual ignition(GNSSAST) 72:virtual flameout(Gsensor) 73:corner trigger 74:overspeed trigger 75:OTA start 76:OTA succeed 77:OTA failed 78:GNSS first fixed 79: low voltage trigger 80: low voltage release 81:Jamming trigger 82: distance trigger 83:crash trigger 84:DI1 trigger 85:DI2 trigger 86:DI3 trigger 87:DI4 trigger 88:DI5 trigger 89:DI6 trigger 90:DI7 trigger 91:DI8 trigger 92:DI9 trigger 93:DI10 trigger 94:AI upper limit trigger 95:AI lower limit trigger 96:battery low voltage trigger 97:battery low voltage release 98:battery start charging 99:battery full charged 100:soft reset trigger 101:virtual ignition(voltage) 102:virtual flameout(voltage) 103:TOW start 104:TOW stop 105: enter GEO-Fence 106: exit GEO-Fence
light_#	Sensors information: light
temp_#	Sensors information: temperature
hum_#	Sensors information: humidity
accel_#	Sensors information: accelerometer
limit_#	Sensors information: Limit (Light,Tmax,Tmin,Hmax,Hmin)
pwr_int	Battery voltage(mV)	mV
charge_st	Charge status(optional): 1 byte 0: invalid 1: uncharged 2: charging 3: full charging 4: abnormal
battery_level	Battery level	%
work_mode	Work mode:1 byte 0: Periodic mode 1: Trigger mode 2: Tracking mode 3: Clock mode 4: Periodic mode+Trigger mode 5: Periodic mode+Tracking mode 6: Clock mode+Trigger mode 7: Tracking mode+Trigger mode 8: Periodic mode+Trigger mode+Tracking mode
imei	IMEI
iccid	ICCID
device_type	Device type
gnss_age	GNSS position age
acc_on_dur	Duration of Acc on
hdop	HDOP
fuel_consumption	The two-channel fuel consumption data adopts the reported data as the Changrun fuel consumption protocol data	(not set)
temp#	Total of 8 channels of temperature	°C
forward_and_reverse	Forward and reverse 0 - unknown 1 - forward (empty) 2 - reverse (heavy) 3 - stop	(not set)
mcc_#	Mobile country code	(not set)
mnc_#	Mobile network code	(not set)
lac_#	Location area code	(not set)
cell_id_#	Cell ID	(not set)
rx_level_#	signal strength	(not set)
armed	Armed/disarmed state 0x00 - is disarmed 0x01 - is armed	(not set)

Parameter name

Description

Units

param_id_#

Parameter value

uart_msg_mode

UART message mode

uart_msg_datatype

UART message datatype 0=ASCII, 1=BIN

uart_msg_data

UART message data

alarm_flag

0,2,3,5,6,9-14,17-27,29,30: Reserved the default as 0

Bit 1: Overspeed alarm

Bit 4: GNSS fault

Bit 7: Device main power under voltage

Bit 8: Device main power off

Bit 15: Remove alarm

Bit 16: Vibration alarm

Bit 28: Illegal displacement of the vehicle

Bit 31: Reserved

state_flag

4-30: Reserved default is 0

Bit 0: 0-ACC off 1-ACC on

Bit 1: 0-GNSS position unfix 1-GNSS position fix

Bit 2: 0-north latitude 1-south latitude

Bit 3: 0-east longitude 1-west longitude

Bit 10: 0-fuel connect 1-fuel disconnect

Bit 30: 0-normal data 1-TOW data

Bit 31: 0-real time data 1-buffer data

odometer

Odometer

gsm

Mobile Network Signal Strength

pwr_ext

External supply voltage in mV

fw_ver

Firmware version

bt_mac_#

Bluetooth MAC

bt_rssi_#

Bluetooth RSSI

bt_name_#

Bluetooth name

bt_fw_ver_#

Bluetooth firmware version

bt_volt_#

Bluetooth voltage

bt_temp_#

Bluetooth temperature

bt_hum_#

Bluetooth humidity

bt_sens_#

Bluetooth sensor (X,Y,Z)

wifi_mac_#

WIFI MAC

wifi_rssi_#

WIFI RSSI

gpio_ch_#

GPIO channel

gpio_st_#

GPIO status

data_type

Data type(0-63 is for GA series, 64-255 is for V series )：

V series:

64:periodic trigger 65:power on trigger 66:ACC ignition 67:ACC flameout 68:VCC connect 69:VCC remove 70:virtual ignition(Gsensor) 71:virtual ignition(GNSSAST)

72:virtual flameout(Gsensor) 73:corner trigger 74:overspeed trigger 75:OTA start 76:OTA succeed 77:OTA failed 78:GNSS first fixed 79: low voltage trigger 80: low voltage release

81:Jamming trigger 82: distance trigger 83:crash trigger 84:DI1 trigger 85:DI2 trigger 86:DI3 trigger 87:DI4 trigger 88:DI5 trigger 89:DI6 trigger

90:DI7 trigger 91:DI8 trigger 92:DI9 trigger 93:DI10 trigger 94:AI upper limit trigger 95:AI lower limit trigger 96:battery low voltage trigger 97:battery low voltage release

98:battery start charging 99:battery full charged 100:soft reset trigger 101:virtual ignition(voltage) 102:virtual flameout(voltage) 103:TOW start 104:TOW stop 105: enter GEO-Fence 106: exit GEO-Fence

light_#

Sensors information: light

temp_#

Sensors information: temperature

hum_#

Sensors information: humidity

accel_#

Sensors information: accelerometer

limit_#

Sensors information: Limit (Light,Tmax,Tmin,Hmax,Hmin)

pwr_int

Battery voltage(mV)

charge_st

Charge status(optional): 1 byte

0: invalid

1: uncharged

2: charging

3: full charging

4: abnormal

battery_level

Battery level

work_mode

Work mode:1 byte

0: Periodic mode

1: Trigger mode

2: Tracking mode

3: Clock mode

4: Periodic mode+Trigger mode

5: Periodic mode+Tracking mode

6: Clock mode+Trigger mode

7: Tracking mode+Trigger mode

8: Periodic mode+Trigger mode+Tracking mode

imei

IMEI

iccid

ICCID

device_type

Device type

gnss_age

GNSS position age

acc_on_dur

Duration of Acc on

hdop

HDOP

fuel_consumption

The two-channel fuel consumption data adopts the reported data as the Changrun fuel consumption protocol data

(not set)

temp#

Total of 8 channels of temperature

°C

forward_and_reverse

Forward and reverse

0 - unknown

1 - forward (empty)

2 - reverse (heavy)

3 - stop

(not set)

mcc_#

Mobile country code

(not set)

mnc_#

Mobile network code

(not set)

lac_#

Location area code

(not set)

cell_id_#

Cell ID

(not set)

rx_level_#

signal strength

(not set)

armed

Armed/disarmed state

0x00 - is disarmed

0x01 - is armed

(not set)

Wialon: the single platform for diverse needs

JX11

Contact Wialon and achieve the most ambitious goals with telematics

Become a partner

Request Wialon in your region