GPS tracker GNX-3 | Integrated with Wialon

Features GNX-3:

4G/LTE
Blackbox
Built-in odometer

Supported in Wialon:

CAN-bus support
Garmin support
Remote management via GPRS
Driver identification
Digital sensors
Communication via UDP

The following data should also be added to GNX-3 unit properties section of Wialon GPS tracking software :

Device type:	GNX-3
Unique ID:	serial

Specify the following parameters in configuration software or configuration GNX-3 for use in Wialon Hosting :

Server port:

21383

4 units of GNX-3 device type are connected to Wialon Data Center. This represents 0% of all AVL Hardware connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name	Description	Units
avg_speed	Speed average used for state determination	km/h
calls_supported	Current services supported by the cellular modem
delta_odometer	Delta odometer from prior event	m
ext_adc	External A2D convertor input voltage. May be used for peripherals such as temperature sensor	V
ext_temp_1	Temperature of external probe connected to input #1 of Sensatronics IT temperature model F RS232 convertor	°C
ext_temp_2	Temperature of external probe connected to input #2 of Sensatronics IT temperature model F RS232 convertor	°C
fw_vers	Firmware version
iccid	The ICCID of the modem SIM card
idle_time	Duration of idling (speed < STOP_SPEED and ignition on)	min
ign	Ignition state
landmark_bearing	Bearing from above landmark	°
landmark_dist	Distance from above landmark	km
landmark	Name of closest landmark, if one is defined
odometer	GNX odometer	km
pdop	PDOP (Position Dilution of Precision)
phone_number	The phone number of the cellular modem (or SIM card)
pwr_supply	GNX primary power supply voltage level	V
reason_code	The reason that caused the GNX to queue this event (number)
reason	The reason that caused the GNX to queue this event (text)
region	Name of region (boundary) in which the GNX is located
rssi	Current received signal strength of the cellular modem	dBm
sec_cnt	Linear second count of the number of seconds since the GNX last powered on
serial_num	12 digit GenX Mobile assigned serial number. A unique identifier for a GNX
sid	Current serving system identifier of the cellular modem
state	MOVING, IDLING, or PARKED, based on parameters STOP_SPEED, MOVE_SPEED, STOP_TIMER, MOVE_TIMER, and the ignition input
stop_dur	Stop duration	min
switch_N	Current state of switch input (ON/OFF). N - number of input
temp	Internal GNX temperature	°C
unique_id	Integer that increments with each position sent, to allow unique identification of each position
wire_ext_tempN	External 1 wire temperature sensor value	°C or °F (depends on the 1 Wire configuration)
bt_status	Status of Bluetooth connection

Please, note: if the serial number of your devices starts with zeros, you should enter Wialon unit ID without these symbols.

For example, serial number 0000123456 should be entered as 123456.

Fill out a request form to get started with Wialon

Products

Niche products for addressing specific tasks

GNX-3

More devices from the manufacturer

Contact Wialon and achieve the most ambitious goals with telematics

Become a partner

Request Wialon in your region

Fill out a request form to get started with Wialon