Tramigo T23

Tramigo T23
Manufacturer: Tramigo
Forum Discussion

Number of units

82
Online
212
Total
Supported in Wialon:
  • ADC sensors
  • Digital sensors
  • Alarm button
  • Communication via TCP

The following data should also be added to Tramigo T23 unit properties section of Wialon GPS tracking software :

Device type: Tramigo T23
Unique ID: imei

Specify the following parameters in configuration software or configuration Tramigo T23 for use in Wialon Hosting :

Server port: 20822

212 units of Tramigo T23 device type are connected to Wialon Data Center. This represents 0.01% of all AVL Hardware connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name Description Units
seq_num

Sequence of message

msg_id

Type of Message
0 - Basic. Contains basic location information and signal quality;
1 - TLD. Contains Tramigo Landmark information;
4 - Trip. Contains information of a completed trip;
20 - Additional information like temperature and device I/O Extended states;
22 - Zone. Contains name of a zone and state if inside/outside of zone;
40 - Analog and OneWire. Values from Analog Input and OneWire accessories of device.

report_trigger

Report trigger code

gsm

GSM signal quality

-dBm
gps_antenna

State of the GPS antenna.

0 = LNA off;
1 = Short circuit;
2 = Internal
3 = External

distance

Current odometer distance

m
pwr_int

Voltage of the internal battery

mV
battery_charging

Units: mV Status of the internal battery charger.

0 = Power disconnected;
1 = Charging;
2 = Battery full;
3 = Charging error

state_flags

Bit flags for the unit status.

0 - Charging. Bit0 is set if backup battery is being charged.
1 - Reserved
2 - Battery Low. Bit2 is set if backup battery is low.
3 - No Battery. Bit3 is set if no backup battery is installed in device;
4 - Bad Battery. Bit4 is set if bad backup battery is detected;
5 - Ignition On / Off. Bit5 is set if ignition is ON. Either I/O based or Shock Sensor;
6 - Reserved;
7 - Parked. Bit7 is set if device/vehicle is parked;
8 - Moving. Bit8 is set if device/vehicle is moving;
9 - Stopped. Bit9 is set if device/vehicle is stopped;
10 - Reserved.

mcc

Mobile Country Code of the current GSM operator

mnc

Mobile Network Code of the current GSM operator

lac

Location Area Code of the current serving GSM cell

cell_id Cell ID of the current serving GSM cell
gsm_status

Status of the GSM network registration

0 = No Network;
1 = Home network;
2 = Searching;
3 = Registration denied;
5 = Roaming network

gsm_temp

Temperature of the GSM module

C
speed_max

Maximum speed since the previous report

km/h
speed_min Minimum speed since the previous report km/h
gps_signal

Units: km/h GPS signal quality 0-100

%
gsm_signal

GSM signal quality 0-100

%
tld_ref_id

IF of the closest TLD location used as reference to previously indicated full TLD information Zero if TLD location is not available

bearing_to_tld

Bearing from the current location to the reference TLD location Units: degrees, 0=north, 90=east, etc.

distance_to_tld

Distance from the current location to the reference TLD location

m
battery_level Battery level 0-100. %
odometer

The odometer of the current trip.

m
driver_id

OneWire device ID of currently attached Driver ID fob.

temp_#

Temp Sensor # temperature

C
analog

Voltage at the Analog Input of the device.

mV
city

Name of city.

district

Name of larger area, like town or district.

landmark

Name of landmark.

country_code

Country where the landmark resides, 2 characters.

More devices from the manufacturer

Contact Wialon and achieve the most ambitious goals with telematics

Fill out a request form to get started with Wialon

Step 1
Step 2
Step 3
First name*
Last name*
Company*
Email*
Phone