OBD tracker Suntech ST500 | Integrated with Wialon

Supported in Wialon:

Remote management via GPRS
LBS
Remote management via SMS
Alarm button
Communication via TCP

The following data should also be added to Suntech ST500 unit properties section of Wialon GPS tracking software :

Device type:	Suntech ST500
Unique ID:	serial

Specify the following parameters in configuration software or configuration Suntech ST500 for use in Wialon Hosting :

Server port:

21223

7 units of Suntech ST500 device type are connected to Wialon Data Center. This represents 0.01% of all OBD trackers connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name	Description	Units
sw_ver	Software Version
valid	0 - GPS is not fixed 1 - GPS is fixed
mileage	Travaled distance	m
mcc	Mobile Country Code
mnc	Mobile Network Code
rx_level	Signal Strength
lac	Location Area Code
cell_id	Cell ID
ta	Information of timing advance
pwr_ext	Voltage value of main power	V
online	1 - Live 0 - Storage
ign	Ignition
pwr_int	Voltage value of backup battery	V
mode	1 - Idle mode (Parking) 2 - Active mode (Driving)
msg_num	Message number
ov_sp_rp	Maximum speed in report time	km/h
ov_sp_time	Time of over speed
spd_2	Average speed in time report	km/h
h_meter	Driving hour-meter
emg_id	Emergency type: 2 - emergency by parking lock 3 - emergency by removing main power
pid_N	Value of pid number N
alert_id	Alert id: 1 - Start driving faster than speed limit 2 - Ended over speed condition 3 - Disconnected GPS antenna 4 - Reconnected GPS antenna 5 - The vehicle went out from the geofence that has following ID 6 - The vehicle entered into the geofence that has following ID 8 - Shorted GPS antenna 9 - Enter to deep sleep mode 10 - Exit from deep sleep mode 13 - Backup battery error 14 - Vehicle battery goes down to so low level 15 - shocked 16 - occurred some collision 18 - Deviate from predefined route 19 - Enter into predefined route 33 - Ignition on 34 - Ignition off 40 - Connected main power 41 - Disconnected main power 44 - Connected Backup battery 45 - Disconnected Backup battery 46 - Alert of fast acceleration from Driver Pattern Analysis 47 - Alert of harsh brake from Driver Pattern Analysis 48 - Alert of sharp turn from Driver Pattern Analysis 50 - Jamming detected 80 - OBD Disconnected with ECU 81 - OBD Connected with ECU 83 - OBD DTC Detected 84 - OBD DTC Undetected 85 - OBD Started high RPM 86 - OBD Ended high RPM 87 - OBD High speed with low RPM 88 - OBD Low speed with high RPM
ac	Acceleration in X axis of accelerometer
hb	Harsh brake in X axis of accelerometer
sharp	Sharp turn in X axis of accelerometer
t_rpm_XXXXX	Time during RPM, where XXXXX - one of 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000, 8000, 9000, 10000	sec
preset_resp	Response values for the Preset and PresetA command

Parameter name

Description

Units

sw_ver

Software Version

valid

0 - GPS is not fixed
1 - GPS is fixed

mileage

Travaled distance

mcc

Mobile Country Code

mnc

Mobile Network Code

rx_level

Signal Strength

lac

Location Area Code

cell_id

Cell ID

Information of timing advance

pwr_ext

Voltage value of main power

online

1 - Live
0 - Storage

ign

Ignition

pwr_int

Voltage value of backup battery

mode

1 - Idle mode (Parking)
2 - Active mode (Driving)

msg_num

Message number

ov_sp_rp

Maximum speed in report time

km/h

ov_sp_time

Time of over speed

spd_2

Average speed in time report

km/h

h_meter

Driving hour-meter

emg_id

Emergency type:

2 - emergency by parking lock
3 - emergency by removing main power

pid_N

Value of pid number N

alert_id

Alert id:

1 - Start driving faster than speed limit
2 - Ended over speed condition
3 - Disconnected GPS antenna
4 - Reconnected GPS antenna
5 - The vehicle went out from the geofence that has following ID
6 - The vehicle entered into the geofence that has following ID
8 - Shorted GPS antenna
9 - Enter to deep sleep mode
10 - Exit from deep sleep mode
13 - Backup battery error
14 - Vehicle battery goes down to so low level
15 - shocked
16 - occurred some collision
18 - Deviate from predefined route
19 - Enter into predefined route
33 - Ignition on
34 - Ignition off
40 - Connected main power
41 - Disconnected main power
44 - Connected Backup battery
45 - Disconnected Backup battery
46 - Alert of fast acceleration from Driver Pattern Analysis
47 - Alert of harsh brake from Driver Pattern Analysis
48 - Alert of sharp turn from Driver Pattern Analysis
50 - Jamming detected
80 - OBD Disconnected with ECU
81 - OBD Connected with ECU
83 - OBD DTC Detected
84 - OBD DTC Undetected
85 - OBD Started high RPM
86 - OBD Ended high RPM
87 - OBD High speed with low RPM
88 - OBD Low speed with high RPM

Acceleration in X axis of accelerometer

Harsh brake in X axis of accelerometer

sharp

Sharp turn in X axis of accelerometer

t_rpm_XXXXX

Time during RPM, where XXXXX - one of 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000, 8000, 9000, 10000

sec

preset_resp

Response values for the Preset and PresetA command

Fill out a request form to get started with Wialon

Products

Niche products for addressing specific tasks

Suntech ST500

More devices from the manufacturer

Contact Wialon and achieve the most ambitious goals with telematics

Become a partner

Request Wialon in your region

Fill out a request form to get started with Wialon