.jpg)
Number of units
The following data should also be added to Suntech ST380 unit properties section of Wialon GPS tracking software :
| Device type: | Suntech ST380 |
| Unique ID: | custom |
Specify the following parameters in configuration software or configuration Suntech ST380 for use in Wialon Hosting :
| Server port: | 21598 |
316 units of Suntech ST380 device type are connected to Wialon Data Center. This represents 0.01% of all AVL Hardware connected.
Below chart represents the dynamic of connections in the last 30 days:
| Parameter name | Description | Units |
|---|---|---|
| mcc | Information of Mobile Country Code |
|
| mnc | Information of Mobile Network Code |
|
| lac | Information of Location Area Code |
|
| cell_id | Information of Cell ID |
|
| rx_level | Information of Rx Level |
|
| ta | Information of Timing Advance |
|
| model | Device Model |
|
| I/O | Current I/O status of the inputs and the outputs: Ignition + Input1 + Input 2 + Input 3 + Out1 + Out2 Ignition : ‘1’ (ON), ‘0’ (OFF) Input1 ~ Input3 : ‘1’ (Ground, Shorted), ‘0’ (Opened) Out1 ~ Out2 : ‘1’ (Active), ‘0’ (Inactive) |
|
| msg_type | Report is real time (1), Report is storage (0) |
|
| cell | Location Code ID(3 digits hex) + Serving Cell BSIC(2 digits decimal) |
|
| pwr_ext | Voltage value of the main power |
|
| bck_volt | Voltage value of backup battery |
|
| h_meter | Driving hour-meter |
|
| dist | Traveled distance in meter |
m |
| col_net_rf_ch | This field brings the information about whether collaborative Network is enabled or not, and which RF channel is set. First digit means collaborative network is Disabled or not 0 means collaborative network is Disabled 1 means collaborative network is Enabled The other two digits means RF CHANNEL set Example 1: 003: collaborative network is Disabled and RF CHANNEL set is 03 Example 2: 103: collaborative network is Enabled and RF CHANNEL set is 03 |
|
| mode | ‘1’ = Idle mode(Parking) ‘2’ = Active Mode(Driving) ‘6’ = ERB Mode |
|
| msg_num | Message number |
|
| sw_ver | Number of the released Software Version |
|
| fix | GPS is fixed (1); GPS is not fixed (0) | |
| fr_serial | Serial number of RF device which is in Emergency mode |
|
| rf_msg_type | Type of Message 1:Emergency Message without GPS coordinates 2:Emergency Message with GPS coordinates 3:Emergency Message without GPS coordinates stored during JAM_DELAY (QUIET_MODE) 4:Emergency Message with GPS coordinates stored during JAM_DELAY (QUIET_MODE) |
|
| rf_volt | Battery Voltage of RF Device which is in emergency mode |
|
| rf_rssi | RSSI in dBm received from RF Device which is in emergency mode. -255 means RSSI is not available. |
dBm |
