| pwr_ext |
Voltage level |
V |
| gsm |
GSM Signal Strength |
|
| imei |
imei number |
|
| imsi |
imsi number |
|
| iccid |
iccid number |
|
| time |
Time stamp |
|
| sats |
Number of satellites |
|
| visible_sats |
Visible satellites |
|
| sat#_signal_strength |
Satellites signal strength, where # - number |
|
| mcc |
LBS Main Cell Tower, mcc |
|
| mnc |
LBS Main Cell Tower, mnc |
|
| lac |
LBS Main Cell Tower, lac |
|
| cell_id |
LBS Main Cell Tower, cell_id |
|
| rssi |
LBS Main Cell Tower, rssi |
|
| lac# |
LBS Auxiliary Cell Tower, lac, where # - number |
|
| cell_id# |
LBS Auxiliary Cell Tower, cell_idm, where # - number |
|
| rssi# |
LBS Auxiliary Cell Tower, rssi, where # - number |
|
| gsm_signal_csq |
GSM Signal CSQ |
|
| battery_vol |
Battery Voltage |
|
| hdop |
HDOP |
|
| sequence_num |
Sequence Number |
|
| inputs |
Input’s Status, Bit 1-4: Door button status (1/0 Door Open/Close), Bit 5-8: Tamper button status (1/0 Removal/Installation) 0xff: Failed to get button status |
|
| boot_reason |
Boot Reason
|
|
| mileage |
Mileage statistics |
|
| real_time_mode# |
Real time current mode, where # - number |
|
| static_parameter_mode# |
Static mode parameter, where # - number |
|
| land_transport_mode# |
Land transportation mode, where # - number |
|
| sea_transport_mode#_1 |
Sea transportation mode parameter 1, where # - number |
|
| sea_transport_mode#_2 |
Sea transportation mode parameter 2, where # - number |
|
| is_geofence_rectangular# |
Circular o rectangular, 0 is circular, 1 is rectangular, where # - id |
|
| is_geofence_exit# |
Enter or Exit geofence, 1 is enter, 2 is exit, where # - id |
|
| status_trig_time1 |
Report status: Trigger time |
|
| status_reg_content |
Report status: Trigger content |
|
| gps_time_status |
GPS is Real Time or Reupload |
|
| alm1 |
Alarm Bit 1 |
|
| alm2 |
Alarm Bit 2 |
|
| alm3 |
Alarm Bit 3 |
|
| sta1 |
Status Bit 1 |
|
| dyd |
Fuel/Electricity Cutoff Status |
|
| sos_num# |
SOS number, where # - number |
|
| center_num |
Centre number |
|
| fence |
GeoFence |
|
| mode |
MODE |
|
| door |
Door status |
|
| cit |
Content of Terminal Information (heartbeat msg) |
|
| temp |
Temperature
|
°C |
| hum |
Humidity
|
% |
| acc |
Ignition state
0: OFF
1: ON
|
|
| data_mode |
Data upload mode - 0: GPS data point upload type (unavailable on GT06)
- 1: Upload in fixed interval
- 2: Upload at cornering point
- 3: Upload upon ACC status change
- 4: Upload the last fix after the status changes from moving to still
- 5: Upload the last valid fix prior to reconnection from a network interruption
- 6: Force to upload a GPS fix upon ephemeris refresh
- 7: Upload a fix upon key press
- 8: Upload location information upon power-on
- 9: Not used
- 10: Upload the last longitude and latitude and update the time after the device goes still
- 11: Parse the uploaded longitude and latitude packet over WiFi
- 12: Upload upon LJDW (immediate position) command
- 13: Upload the last longitude and latitude after the device goes still
- 14: GPSDUP upload (upload at a fixed interval in still state)
- 15: Exit tracking mode
|
|
| gps_data_reup |
GPS data re-upload
0: Real-time upload;
1: Re-upload (unavailable on GT06)
|
|
| vehicle_status |
Vechicle status
0: The vehicle is idling
1: The vehicle is stopped with engine off (stationary)
2: The vehicle is in motion (moving)
|
|
| charging_status |
It indicates the charging status of the device
0:Device is not charging
1:Device is charging(External power)
2 :Device is charging(Solar power)
|
|
