GPS tracker Skypatrol ST7200 | Integrated with Wialon

Features Skypatrol ST7200:

Blackbox

The following data should also be added to Skypatrol ST7200 unit properties section of Wialon GPS tracking software :

Device type:	Skypatrol ST7200
Unique ID:	imei

Specify the following parameters in configuration software or configuration Skypatrol ST7200 for use in Wialon Hosting :

Server port:

21445

3 units of Skypatrol ST7200 device type are connected to Wialon Data Center. This represents 0% of all AVL Hardware connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name	Description	Units
event_id	Event ID: 4001 - Wired Ignition ON 4002 - Wired Ignition OFF 4003 - Virtual Ignition ON 4004 - Virtual Ignition OFF 4005 - Main Battery Disconnect 6001 - Direction Change 6002 - Speed Threshold 6005 - Mileage Threshold 6008 - Main Battery Threshold 6009 - Main Battery Disconnect 6010 - Main Battery Reconnect 6011 - Wired Ignition ON 6012 - Wired Ignition OFF 6013 - Virtual Ignition ON 6014 - Virtual Ignition OFF 6016 - Idle Threshold ON 6017 - Towing Started OFF 6018 - Towing Stopped OFF 6019 - Input 2 High 6020 - Input 2 Low 6021 - Power Shutdown Pending 6022 - Power Shutdown Canceled 6030 - Movement Started 6031 - Movement Stopped 6032 - Parked Time Threshold 6004 - Geofence Crossing 4006 - Heartbeat 6015 - Power Up/Reset 4050 - Diagnostic Data 7001 - Locate Now 7005 - Enable OR Disable Starter Output 3011 - Enable OR Disable Late Payment Buzzer 6026 - Wake on Motion Use last known 6021 - Power Shutdown Pending
hdop	HDOP
pwr_ext	External Battery Voltage
gps_status	GPS Status: 0 – no lock 1 – locked 2 – no comm 3 – GPS OFF (power save mode)
gsm	GSM Signal Strength
out_state	Output State: 0 – Short circuit with GSM override enabled 1 – Open circuit 2 – Short circuit
miliage	Miles driven since last reset or power cycle
ign	Ignition Status: 0 – OFF 1 – ON
pwr_int	Internal Battery Voltage
last_mode	Last Power-up/Reset mode: 1 – S/W Reset 2 – DC Power-Up 3 – Motion Sense
geofenceN	Geofence Information with N - Geofence ID number (0 – 9): 1 – outside geofence 2 – inside geofence
fw_v	Firmware Version
pf_name	Profile Name
gsm_st	GSM Registration State: 0 – Not Registered 1 – Home 2 – Search 3 – Denied 4 – Unknown 5 – Roaming
gprs_st	GPRS Registration State: 0 – Not Registered 1 – Home 2 – Search 3 – Denied 4 – Unknown 5 – Roaming
gprs_pdp_st	GPRS PDP State: 0 – Deactivated 1 – Activated
h_disc	Hours Disconnected
h_on	Hours ON
pw_up_c	Power Up Counter
reset_c	Reset Counter
lost_gps	Percent Lost GPS	%
lost_gps_5	Percent Lost GPS based on 5 Satellites	%
lost_gsm	Percent Lost GSM	%
lost_gprs	Percent Lost GPRS	%
lost_pdp	Percent Lost PDP	%
Low Voltage Counter (# of sec < 9 Volts)	Low Voltage Counter	sec
high_volt_c	High Voltage Counter (# of sec > 16 Volts)	sec
cont_act_c	Context Activation Counter
d_byte_out	Data Bytes Out
ack_byte_in	ACK Bytes In
dota_byte_in	DOTA Bytes In
sms_out	SMS Msg Out Counter
sms_in	SMS Msg In Counter
sms_spam_in	SMS Spam Msg In Counter
bz_state	Buzzer State (if equipped in device): 0 - Buzzer OFF 1 - Buzzer Pattern 1 (slow beeps for 10 sec) 2 - Buzzer Pattern 2 (fast beeps for 10 sec)

Parameter name

Description

Units

event_id

Event ID:
4001 - Wired Ignition ON
4002 - Wired Ignition OFF
4003 - Virtual Ignition ON
4004 - Virtual Ignition OFF
4005 - Main Battery Disconnect
6001 - Direction Change
6002 - Speed Threshold
6005 - Mileage Threshold
6008 - Main Battery Threshold
6009 - Main Battery Disconnect
6010 - Main Battery Reconnect
6011 - Wired Ignition ON
6012 - Wired Ignition OFF
6013 - Virtual Ignition ON
6014 - Virtual Ignition OFF
6016 - Idle Threshold ON
6017 - Towing Started OFF
6018 - Towing Stopped OFF
6019 - Input 2 High
6020 - Input 2 Low
6021 - Power Shutdown Pending
6022 - Power Shutdown Canceled
6030 - Movement Started
6031 - Movement Stopped
6032 - Parked Time Threshold
6004 - Geofence Crossing
4006 - Heartbeat
6015 - Power Up/Reset
4050 - Diagnostic Data
7001 - Locate Now
7005 - Enable OR Disable Starter Output
3011 - Enable OR Disable Late Payment Buzzer
6026 - Wake on Motion Use last known
6021 - Power Shutdown Pending